开云体育

as i said this is a kit ,and the display can be fitted anywhere so that answer doesent help,can folks not refer to the schematic and tell me?.

On mine the RF in is on the left when looking at the display. -- Colin - K6JTH http://tangokeys.com

ok but the reason i ask is this was a kit,all i have to go on is the schematic,it doesent say ant or radio just in and out!,if it wasnt clear i wouldnt of asked!. wrote:

Paul, The tuner uses a PIC chip that is different than an Arduino. The PIC must be programmed with a PICkit 2,3,or 4 and software for uploading the firmware to the PIC via the PICkit. The answer to

Hi Paul, The antenna connects to the ATU100 on the ANT port and a jumper connects to the transceiver on the RF in port. I use a morse key to send a signal from the transceiver to tune. -- Colin -

Hi all,I have just finished my atu 100 kit build and fitted it in a case,silly question but does the antenna go to the in or the radio?,also will it automaticaly tune when i put rf into

Hi I have an unbuilt ATU 100 kit for disposal. When I say kit, the PCB only has the processor and the tuning caps fitted, the remainder of the parts, including surface mount types are provided but

Hi, Paul ATU-100 is the fully open source project and you can find all the info in one place https://github.com/Dfinitski/N7DDC-ATU-100-mini-and-extended-boards even instruction manuals on different

Hi. As I know Icom can do that if you will connect a tuner to TRX via Icom Tuner interface. But this ATU can to initiate new tuning automatically everetime when high SWR detected so the TRX

Hi, Paul. Theoretically it is possible to create a sketch to programm needed processor, a simple serial protocol is using but I never heard about somebody did it. It will be smarter to buy a cheap

His answer was ’NO it can’t” and he was helping you by telling you what you need to program the ATU-100. They are totally different chips. If you had done some research you would know

Come on moderators, there is no need for this. Some folk you can’t help.

Dave you say the answer was done,how is that then?,i already know a dedicated programer can do the job,the whole question was about trying to use an arduino to do the same,telling me to buy a pkit3

Paul, the answer was done. Please more polite.

Pull your head in mate. Sent: 6 January 2023 11:41 AM To: [email protected] Subject: Re: [ATU100] programming the atu 100 not answering what was asked doesent help!,Do you have verbal dioreaha

why not tell/show what pins were shorted to help others/,you gave only half of the answer!!.

is it possible to make the atu100 retune eveytime the radio changes band?,like a normal internal atu,using data from the radios acc socket/.73 m3vuv.

I was only trying to help Sod you

for what its worth powering my kit build chineese atu-100 from my lab psu,i find it works( not tried to tune!) well the display is on down to about 6.5v.