开云体育

Onno, I'd be very glad to help.? I am a software developer and write in C and C++ all day long, for embedded processors.? I've just pulled down the source code for version 3.2.? ? My PICkit 3

Hi, I made a 1500W tuner according to the EU2AV scheme (PIC 16F1938 processor). David N7DDC firmware based on old version 2.7. Question for David, is it possible to do it on software version 3.1 or

Hi David, OK, understand the string length, can you reveal where it can be changed ? RR re SWR on 6m , I fixed mine? - I found the one of the SO239s on the back panel was slightly

Hi David, I understand it's easier to use microc ide because that's the environment used for the original program. Unfortunately the cost associated is high. Combined with a pic 4 programmer I would

Hi. You have to change some specific built in functions like Button , ADC, Conversion. Also pic configuration and ports settings. Nothing difficult but it can take a time. Better use MicroC IDE.

I am currently reading into it and writing new code using Mlab x compiler. Started last week. Regards Onno Op di 16 nov. 2021 18:16 schreef The Hempsteads <dbhempstead@...>:

Hi, Tim. You can change the prescription ATU-100 trough a hex changing but you can not add any symbol more in that string. To All - 1000 W version is much larger physically , has different relays and

Hi, Has anyone thought about porting the mikroC code over to the MPLAB X IDE (with it's C compiler)?? ?The MPLAB IDC and toolchain is free, connects directly to the PICKit for programming.? ?The

So, after reading about this particular design i stumbled over various stores selling supposed clones of the design. As it suited my needs and my price point i pulled the trigger and ordered one. The

Hi You probably need to give more information. It's often difficult to diagnose remotely, any electronics. At least what PCB are you using, software, what exactly is the problem, etc. vk3pe

Ok understood. So the code relies on embedded functions as offered by the microc compiler environment. Unfortunately this makes the code difficult to use with other compilers. I will check if I can

I don't have such high see on 50 MHz. Bypass relay is normally closed and with power off swr is 1.1:3. When power is connected and unit switches to bypass the relay is closed too. Tuning on 50mhz

Hi David, OK, thanks - the Russian 1kW unit purports to operate to 6m and it does tune there nicely but the through SWR is higher than it should be. A question for you... Where in the hex is the

Hi, Tim. That is normal behavior, because on my tuner this position of C switch relay gives better SWR. Please keep in mind, ATU 100 tuner works well on 3.5 - 28 Mhz only .

W pl mog? pomóc Wys?ane z My iPhone

Hi all As stated in the topic,?Anyone in Germany able to repair ATU-10 ?

Hi, MikroE, MikroC Pro for PIC.

You are welcome!

Thank you Patrice! Great! Op zo 14 nov. 2021 21:59 schreef F1RVC <f1rvc.patrice@...>:

Hi Patrice! That's great to have. Thank you very much! Regards Onno Op zo 14 nov. 2021 22:06 schreef F1RVC <f1rvc.patrice@...>: