开云体育

I have tried with various approaches so far but none is working. I even installed VMware and valid windows XP os and still it did not work because of the USB interface. I surrendered and ordered a

Thank you David and VA3RR for your comments. I found http://www.circuits.dk/calculator_single_layer_aircore.htm to be quite helpful but it raises the question : When a schematic reads "4mm Air Core"

Hi. the best way - to follow recomendation you found on the original schematic.

Hi. The tuning process will start automatically when large SWR is registered. The most advantage of using External control connection to IC-705 - a tuning process will start automatically every time

Hi David, Thanks for information… What do you get when connecting with a 3.5 mini jack cable? As you disconnected, the tuner continues to tune automatically when changing frequencies. I do not

Hi, Marek Did you see this video ? https://youtu.be/oanICrrSyFE?t=333 No any special settings, exactly like AH-705

Good day all. After watching too many YT videos on the AT-100 , I admit I have one question remaining. My kits paperwork shows L1 as being a 3 turn on 4mm giving a 0.05uh value. I have seen built kits

Hi, Onno I think you can use a Windows emulator on your Linux machine and run PICkit 2 or 3 suite (not IDE) https://drive.google.com/file/d/18wiH5RjL5R8ku7a9MQ4Hxx9SmUZInpvj/view?usp=drivesdk To use

Hi Onno Use MikroC for PIC , MikroE. https://www.mikroe.com/mikroc-pic

Hi, Is there some documentation on how to compile the source code? Perhaps I can contribute too? Regards Onno Op zo 7 nov. 2021 21:45 schreef David Fainitski <rolin791@...>:

Hi, people. I dont remember who exactly asked me about this problem, sorry. Firmware 3.2 has been updated, display off timer issue resolved. Ignore this update if you don't use a display off

I hope someone has experience updating the pic processor using command line instead of installing an ide to just push the bytes to the processor. I can access the pic processor, read the data and

As far as I am aware, you need a PICKIT3 not the older 2 version

Hi, Hope someone has experience with the following; Ubuntu OS, pickit 2 and pk2cmd. That's the current environment I have available. I am able to program the PIC CPU but it seems I am doing

Hello , Someone tested communication and automatic operation with the ic-705. Do you have to set something up in icom? Marek SQ7BCN

Thanks Glenn, The overlay by value is how I found it, R1 was the only resistor not populated so I went looking for it. This sort of thing is to be expected in such a project, working it out is half

Hello All, The board and case are taken. Cheers and 73, Dan VE7CTN

Good catch Ellis Has been fixed on *web page.* ( http://carnut.info/ATU_N7DDC/ATU-10/ATU-10%20build.html ) The overlay by value section should be fine though. Glenn vk3pe

Hello All, About six months ago David sent an original board (cost recovery: ?board plus postage) to me. Thanks David. ?I then ordered the matching case from Alibaba (25x71x100 mm) to house the

Hi. Most likely, use Google