开云体育

Hi Onno, Thank you.? The Windows software does a verify after write by default.? I click the "write' button and it writes but the verify fails.? It's intermittent where it fails.? Not always at

Sounds to me you might have forgotten to "release" after programming. I don't know how the windows interface looks like but look for reset / release after the write sequence. Best regards Onno Op vr

Hi all - This is a fun little project! Just finished my build and realized that there is a newer firmware.? I ordered a PickKit 3 clone from ebay and downloaded the programmer software from the

David What ports do you plan to use for the manual tuning? There are currently 4 spare port pins on the PIC16F18877. Glenn

We can run a diff on the versions to see the real difference. It is also possible to convert the hex file to assembly and see the changes. I will see what I can do this weekend. Regards Onno

Hi, The difference is that the LCD is to show the power value, e.g. 1500W, which probably will not be shown by the version with the unadjusted program (for Flash). This is what Yuri EU2AV suggested to

Hi David That would be brilliant 73, Jon G4TSN

Hi David, thanks a lot for your efforts! Vy 73 de Rolf, DL8BAG Rolf

Hi. OK, I will implement zero position for L and C. That is not a big problem. Also I can do a manual tuning L and C with additional buttons + and - connected to Ext port .

Hello Ellis, How much output did/do You use in FT8 via the ATU-10, I think 5W is possible to much? 73 de Frank PH2M

I can only think about the swr bridge being different with the potentiometers. The pic controller adc is the same. I have looked for alignment information but unfortunately. Instead the easiest

Good news then!Sent from my Samsung Galaxy S7 smartphone.

I found a short that was causing the battery life issues.

Hi Tim, When it comes to the EE data, I can make a copy of it, because I have worked out the topic ... see the attachment. But it's not just about EE, so EU2AV wrote to me that there are even changes

Many thanks, this is more than I asked for but will be extremely useful as I actually need the same thing as what SP5GNI has done, so it is "off the shelf" for me! 73 Yannig, F4IUJ

Hi Marek, 3.2 works fine in the ATU1000 BUT... Make a copy of the eeprom data 1st. ( this is what I didn't do with mine and it took a while to work out the cell values ) This is because the EU2AV

Thanks to everyone who helped me with this, I now have a much better understanding of my unit. regards Tim -- VK2XAX : QF56if : ITU59 : CQ30 : BMARC : WIA

Hi, I have completed my build and made my first FT8 QSOs today. The battery life seems poor, but I may have managed to get low capacity batteries.? There are batteries available on eBay In the UK

Hi David, yes I know the test firmware and it’s very helpful for checking relays. However can we have a special state to bypass all the inductors or capacitors? My understanding is with the current

Hi, All Please notice that my GitHub contains a special test firmware. I hope it would be helpful in issues fixing.