开云体育

That would be sufficient to keep bugs out. I used the word "cap", but maybe that implies a seal. Just something to keep insects out. I've discovered very small leaks by the presence of flies. Maybe

Thank everyone so much for all the great ideas for making it possible for me to raise my Aliner by myself.? I plan to try out several of the ideas and see which one works best for me. Thank you

Yes Chalet claims to have a patent. There is a You Tube video I saw showing it in operation. Pretty slick. Sent from Wayne’s phone

That's good to know.? I probably lucked out then because when I disconnected the propane i covered the end with a wad of paper towel and a rubber band since i didnt want an oil stain on my garage

we have the "Wind assist lift" pole only on one side.? Aliner would not sell me just one; said there wasn't room for one on the other side because of the holding tank vent--actually there is room.

BTW, if you disconnect propane lines for more than a very short time, you should cap them. Over 500 hours flying hot air balloons taught me that flies and some other insects are drawn to the scent,

A lot of talk about Buddy heaters acts like Aliner are air tight. I have a brand new 2020 Titanium12 it’s been used once and I really like it. I had heard they were drafty I was shocked about how

Except for the stove top burners, the other appliances don't expel burning products in the trailer. The refrigerator, hot water heater and furnace exhaust burning products outside. You aren't

You know there are trade offs for using the buddy heaters vs the installed propane furnace.? The buddy heaters are quiet and more efficient since they vent indoors.? But one by product of combustion

Slim Potatohead, a Canadian Aliner camper on Youtube, great shows, by the way. He uses those plsstic foam noodles, the toys, and fits those in, also for desert windstorms. Barbara

GKS Wind lift assist kits re available from Aliner parts. Expensive but worth it. I had local shop install them. This guy has added an improvement to the kit and you can see it in action:

The “lift assist” is two poles that can be used to lift the roof and after you’re set up, they lock the roof panels in place for extra security. For a smaller model they make it a cinch for even

what is "lift assist"??? I definitely need some! thanks.

Your link came through, but the image or whatever was with it did not. Wonder if these run on the reduced gas pressure of the Aliner.

https://www.amazon.com/dp/B000HE8P2O/ref=cm_sw_r_other_apa_i_alyWDbVS58QMK On Tue, Nov 5, 2019 at 5:01, Hap Kimmel<pilothap@...> wrote: I just finished removing the factory installed heater in

I just finished removing the factory installed heater in my 2008 Aliner Classic. I also have a portable little Buddy heater. Where did you get your quick disconnect hoses and does it require a filter

Working great..... love that pictures can be posted! On Tue, Nov 5, 2019 at 5:21 AM, elegy3983<airpilot1@...> wrote: As you can see, since your posting appeared in the forum, you, and all

As you can see, since your posting appeared in the forum, you, and all members of the old Yahoo Forum, have been automatically enrolled.?Welcome!?Dave.........?Does this mean that we are

Small Typo, Sorry.

Hi Gang: Our biggest problem with condensation was dripping from the top ridge. We but a vinyl strip from those walk in cooler doors across the gap. It keeps the moist air away and if the condensation