开云体育

What are vacuum panels, and would they be appropriate for a floor?I'm in Florida so I'm not sure how much insulation I need from below.

Many decades ago I had a window AC in a room mounted in a window that was recessed from the main room. To get the cool air to blow out and then at right angles into a dead air space corner I taped a

Don, how's your frame repair and floor rebuild coming along?

Hi Don: Coosa says 2 to 3 times better R value. Better with water, but not immune. The best would be vacuum panels, the vacuum space doesn't matter as long as it is greater than zero. Carl.

Carl, I'm putting my camper back together after replacing the floor with 3/4" Coosa Bluewater 26 board.? Primarily a marine product.? It is?Fiberglass Reinforced Polyurethane Foam.? I would think

I noticed that there was no insulation between the top of the refrigerator, and the counter top in my 2009 Classic.? The fridge generates a lot of heat.

Hi Gang: We put 3" of exterior roofing Styrofoam under the floor, it helped. Carl.

It appears that each model of Aliner has a different configuration of air ducts from the heat pump.? Our expedition has 3, several folks have mentioned that they have 2, and the late model LXE also

Patricia, I got a package of 3/4” styrofoam panels at Lowe’s/Home Depot? I cut them with an old kitchen knife heated up. Most are friction fit between the 3/4” thick supports. Some needed to be

Thank you Joe, for this suggestion.? I may give it a try.

Hi Steve, I was in awe of your accomplishments in under a month. Sorry, I’ll have to remove your Superman cape. ?I am completely new to trailers. We bought our 2022 Aliner Classic in late September

Hi All,? ?Thank you for all these comments.? I'm in Dallas, Tx. and bought a 2024 LXE last November.? I believe that I have a similar set up with the air conditioner and heat pump.? I'm planning

Hi Joe.? First, let me clear up that the mods I listed in these messages were NOT mine.? Other, creative owners, have done these and I was just interested in them.? My apologies if I led anyone to

Steve, Your modifications look great and EASY! ?I rerouted the cooling hoses to give us more usable room under the bed. Yes, I probably reduced the efficiency by restricting the flow in and out but

Installed a wired dash cam with front and rear views as a documentation device for any vehicle accidents that might occur.? But I also rigged it to work for the camper.? I bought a second camera for

I installed a DoHonest v25 wireless backup camera ~$80 a year ago. I mounted it high on the back of the camper and ran a wire to a fused water resistant switch on the outside of the camper battery

Hi again Roy.? I apologize that I did not include some other info with the pics I sent.? The product used was called StealthFlow Amerimax.? I found it on Amazon ( https://tinyurl.com/3msye22f ) as

Ah, thanks for those photos, Steve! Although I have done some fiberglass work before, the construction definitively would have taken me quite some time ? So I'm definitively interested in easier

Correction:? our 2021 Expedition Offroad has three(3) vents, rather then the two(2) in the mods I have reviewed.

Thanks for the information and links, Roy.? I plan to make some mods to my HB9000, but am considering options.? The mod explained in my first post, above, involves fabricating ducts out of thin