开云体育

I've just been notified that one of the wind kit arms on my 2016 Aliner Ranger 15 has been damaged. ?How do I go about replacing it? ?I'm not in North America right now so don't have it in front of

I inadvertently started a new threat on this.? ?It must be because I changed the subject name and put the word update in front of it.

Hello: We don't have struts, but I found the pop rivets giving way. I put a 1/4" bolt between all the rivets and extras at the ends. Very stable now. Why did they use pop rivets in such a high stress

I bit the bullet and finally mounted two 30# gas Springs on the front section. I like them, they are mounted at 72° when open.? They don't quite provide the lift needed to make them neutral.? As

hi gang: we had a bearing cap with a zerk and I pumped grease in before each trip. the bearings were always almost too hot to touch. the break mechanic cheched them and said "too much grease" and

Might the hot side been the sunny side while traveling?

That's just scary...? That entire axle is trashed...?..........?One way to know the hub is too hot is when the orange light comes on.

You mean "ballpark" max temp? Nothing official that I know of. Normal hub temps are usually about 150 degrees F. or less. 200 degrees or more would concern me.?Dave?...........??Is there a

Nothing. To read hub temps with a non - contact infrared thermometer, the hub has to be exposed. I recommend removing and discarding wheel hub caps, so the hubs are always exposed.?Dave?..........

One way to know the hub is too hot is when the orange light comes on.

This raises a question for me.? What do you have, if anything, covering the hubs?? I would have to remove my wheels to check the temp.

Great ideas. Thanks so much!

Point taken Dave. I'll definitely pick one up. Is there a "ballpoint" temperature at or over which one should be concerned? Thanks again. Jerry

Might the hot side been the sunny side while traveling?? I notice a difference on the sunny side and will get to the point of uncomfortable to touch.? And combined with brake heat.

Mike Gonda's gutter installation (really an extender, not a gutter) was mounted flush to the top surface of the roof extrusion, so that rain water simply cascaded over the extender edge and onto the

Jerry: A couple of observations: 1. Did you know that environmental conditions can impact hub temps? If one hub is consistently in the sun while the other isn’t while you’re towing, or if the

Rick, the ones I have are different from this used on the A wall pics.? Mine are made to be flat.? Ultimately I switched to a vertical slide bolt.

Hi again folks.? Several days back, Dave described an improved method of adding rain gutter gutters.? I would like to install a set.? ?However,? I'd like a further description of where the

Hi again folks.? Several days back, Dave described an improved method of adding rain gutter gutters.? I would like to install a set.? ?However,? I'd like a further description of where the

Hi again folks.? Several days back, Dave described an improved method of adding rain gutter gutters.? I would like to install a set.? ?However,? I'd like a further description of where the