开云体育

Hello, I need some help selecting the appropriate torque wrench to torque the wheel nuts on my 2022 Scout Lite which will be delivered to the dealer in early August. According to the manual online, it

Mine is on a thermocouple. When the fridge is running I turn on the switch. The fan starts when it gets hot and turns off when it’s not. Simple! Cindy ————- Cindy 2017 International Autoharp

Steve T wrote:? If you put in a computer case fan of about 1200 rpm that will draw about 90 mA, and if you run it for 12 hours a day... Which begs the question of, "What is the best time/situation to

If you put in a computer case fan of about 1200 rpm that will draw about 90 mA, and if you run it for 12 hours a day that will be 1080 mA or 1.08 Amp Hours.? A typical battery has 100 Amp hours of

Hello Kathryn: If the fan is running it is using the battery. The question is how fast is it running the battery down. Computer fans use much fewer Amp Hours than the junk fans from the factory, so

So if I'm boondocks boondocking, that fan I put in isn't going g to drain the battery?

Try a Purina Tidy-Cat plastic container (has a hinged top and carrying handle. Just drill a hole in the top enough to fit a washer cold/hot water hose with one of the end fitting cut off stuck in the

Since we never had good success running our fridge on DC while travelling, I finally got around to powering it on AC from the towing vehicle. This worked much better this weekend and arrived at the

Nice set up. Smaller for carrying to a dumping station. Thank you for sharing! -- Lois-Ann Holmes PO Box 187 Old Town ME 04468 (207) 825-3688 (mobile) Confidentiality Notice: This email and any

Here is what I do with my grey water. i bought a plastic 5 gal tank, and I chose a blue kerosene one because it is a color you rarely see and not likely to confused with a red one for gasoline. I

Thanks for your responses.? I guess I'll just drill a couple of drain holes into the bottom of the frame members and see how this works as I do not like the idea of water laying in there for days or

Bob, the diagonal beams that come together at the hitch have front ends that are as wide open as the air intake on a fighter jet.? The aft edge of the diagonal beams are completely sealed.? The

Hello Bob: I've never noticed any, but since we keep ours inside a shed it doesn't see much rain. I have drilled into the frame for the belly pans, and no water came out. Carl.

Hi Carl,? Maybe the frame builder or Aliner forgot to put drain holes in mine, as that was one of the first things I checked for.? Do your frame members have drain holes or are they open at the back

Thanks Steve. I knew someone had a rational for what they used.

There is no best, just tradeoffs. If you're doing just the glue fillets around the fixtures or the metal roof trim, you can use a bunch of different things without much downside, as long as it's a

Hello Bob: I think the frame builder put drain holes in, and they have become plugged. I would search the bottom of the front and back of the tubes. Plus I would look for other holes that are letting

Hi All, I know this has been discussed ad nauseum before, but I cannot seem to come up with the posts. I seem to remember a lot of controversy about what is the best type of caulk to use. Silicone or

On Chalets they don't weld the bottom of the lengthwise beams to the rear bumper, and the fronts of the beams are open too, so no water collects inside. I'd drill holes in the bottom of the lengthwise

I have noticed that there is water inside the two box frame members that run the length of my aliner and which support the axle.? There is a small hole in the front of the camper and a larger one in