开云体育

You can also permanently mount the lathe on end and use it vertically. Ralph gcvisalia@...> wrote:

Animal is correct; you also were limited by the footprint and height of what was mounted on the rotary portion of the “table.” I had one for a couple of years with a small jointer, benchtop

I use cardboard. I use it under the ways. Its deep enough to reach from the front of the bench to near the rear of the bench. I also have large piece as backsplash. It rests on the piece under the

1- what? ?do? you thing? about ouging? thecnic 2- do? you use? it sometime 3- is it? need a special? equipment 4-or? only? welding? equpment? whit? special? ?rcarbon? rod jack 47 71

I've been storing my mini-lathe vertically for years, and it works fine. What I did was make a wooden plug for the left end of the spindle. Part of it is turned down to fit snugly inside the spindle.

hit send to soon . probably the best bang for the buck would be the tool box under the lathe , Ya just push it out of teh way when needed & no extra setup time when ya want to use the lathe . They

IIRC on that Craftsman rotating bench that ya had to slide the top out to the side on either side of the center top before ya could spin the centerpiece . animal

Recheck your work. If it wasnt there before and now it is after you put the motor back on, then something went wonky when you reassembled it. Pinched wire ? Misconnected wire ? And for sure, a good

I have rechecked everything mentioned and that yielded nothing notable. There was no jamming or anything of the sort. The switch operates as it should. I still get a fault (yellow lamp is lit. I am

charles wrote: Wow. That thing's amazing. Might work better on paper than in practice, indeed! But I can certainly see the attraction. Comes with a free cord winding mechanism! ;-) In addition to the

If you do something like store it on a bench to the side front to back, you could have a shelf surface above where the lathe is stored to provide some additional flat surface.? You would still have

Charles, thanks for all your thoughts on chip cleanup. Sounds like the problem is about what I thought it would be. A problem, for sure, but not insurmountable. There's already a rug on the way out of

mike wrote: Ha! That's great! It's particularly amusing to me, since my main reason for getting a lathe is that I collect and restore antique sewing machines, and they sometimes need parts or screws

Sound like work just fine. Watch length to short and may give problems with dills and boring . Need at least 12" between chuck face and tail stock. Dave FYI I have 14" between chuck face and tail

Think wheels.? I have my mini lathe on a HF cabinet that provides storage for all the accessories that one tends to accumulate.? 3d printer mounted on a rolling cabinet from Home Depot that provides

I would think that if yer gonna try to store a mini lathe on end that is should be mounted to a solid base for horizontal use that can double as part of what would be needed to hold it vertically .

The fuse can only protect when there is only one path for a return current and fusing N does not protect L from returning on GROUND. Yes, it does matter where the fuse is. wrote:

I don't see any reason you can't store a mini-lathe on end.? (Unlike some larger lathes, it doesn't have any "oil bath" areas where oil could run out.) Regarding clean up, usually it is common to

On the electrical and computer side, it is just LCNC with three stepper motors, So the LCNC documentation applies. But on the mechanical side, there is custom-made parts that fit the motors to the HF

My small shop is decidedly mixed-use: wood work (manual, plus occasional CNC milling), some electronics (Raspberry Pi type stuff), general homeowner workbench use, and, hopefully someday soon,