开云体育

I had mine shipped to my home ? . It light enough so my self and wife could pickup and put on the table. All from Walmart. Dave

I bought a Speedway 7X12 about 20 years ago for $300. Many mods later I am still happening with it. I replaced the 3 inch 3 jaw chuck with a4 inch one from LMS. Regards John Mattis

I will just say that I bought the original HF 10" lathe and used it for many, many years before buying a longer bed kit when they were on sale from LMS. So if you find a good lathe at a good price,

they probably hang out with the cocaine bear . animal

Here's something to think about when it comes to Chinese-made machinery. They are not the same thing even if they are products from the same factory or the same brand. In china, cabbage, for example,

Following that GadgetBuilder protocol, I cleaned surfaces, applied DyKem and mated the headstock and ways, sliding them 1/8" forwards and backwards. Contact areas are left and right rear flats and

I went with 14" size Preenex? 8”x14” Mini Metal Lathe just for a little extra room . I did think of 16" too but have stop on size . I limit my decision by weight keeping under box weight 140

Got a friend with a surface grinder? Setting the headstock up with the spindle bore parallel to the table and cleaning up the base of the headstock would do wonders! The cheap way might be to use

It all in the Reindeer for flying. The Reindeer are test all time for flying. Dave

Yes - Santa exhibits quantum entanglement - he's everywhere all at once.? And if you observe him, he gets locked into a specific state.

I’ve got “The Complete Mini-lathe workshop” on order, thanks. As noted in https://gadgetbuilder.com/Lathe_Align.html bolt torque appears to be good for only 0.0005-0.001” vertical at best and

?Spoilsport ???. Seriously thanks for the calculations. Very very interesting….. However, may I point out that as he has,, in fact, magical powers eg. going into houses or apartments

Recent posts above should dispel any consideration of the 7x"10" lathe.? ?This variant, 7x10, has been so advertised for decades, and it is NOT 10", it is 8".? ? You will quickly find the use of

why all the interest in Santa Claus?? Science has proved that he could never 'service' all the children round the world in one evening. Here follows a scientific explanation for all the doubters (an

It depends on how they "fly".? Them other quadrupeds might find themselves in the same sleigh (AKA boat) if they ate Rudolph!? I mean, reindeer are known to like eating some kinds of psychoactive

What ralphie said is good sound advise . I just went to Grizzly tools site cause its easier to do a comparison there . SO to go up 2" in bed length cost ya a extra 3" of width , the 9x19 is only 6"

I did not know that apart of HF lathe. I came very close to buying one. The I did purchase is 13.8" CC and by time drill chuck it getting short too. But this was because I down size was problem and

Remember, it's really on a 7 x 8, not a 7 x 10.? You'll wind up replacing the bed with a longer one, as a 7 x 8 fills up fast with a chuck in the tail and any size drill bit.? Think longer...

I look at Harbor Freight Looks nice and does but turning at 2500 rpm. I got all belt drive and is quite to run. As longe can live gear noise it is a great mini lathe. Dave

Search is on temporary hold.? Finally realizing I'm gonna actually get a lathe I first need to clear a spot for it. Bigger job than expected. Meanwhile all this is going int my decision.? I'm