开云体育

Yep, the PC drilling machines I have seen were branded DAK they used high speed electric drive spindles, 10K rpm?? and we used small collet held carbide drill bits, they were CNC?

There are "printed circuit board drills" that I believe are carbide. Amazon has inexpensive ones.? Professional industrial ones cost more.? The are all quite brittle and easy to break.? They are

I have some cpu 486 or pentium vintage version But impossible to drill a ho;e in the material Normal drill for Metll Nothing Drill Diamand for glass or stained glass Nothing barely trace Probably

I still have no real idea on what caused the failure of the transformer and switch.? I just replaced the parts and hope for the best, with the lurking feeling that it will happen again.? I now do

Here working next is converting my cross slide to ball bearing. *Very easy tooy* . *Using a motor grade 6201 seal* Thd pdf is clearer than screw shot. I did not put here so did use space here if see

Thank you all for the feedback. I haven't devoted any real time to work further on this project, but wanted to acknowledge I didn't notice a thermal fuse bump on the transformer.? But it's on the

Weird fault. Very uncommon for a transformer primary to die, they often have thermal fuses which fail. They’re supposed to fail if the transformer overheats (Hey Dave, sound familiar?) but

Thanks Gary Anderson ( # ) The link to the manual is very helpful, and I had never used the Drafts button despite using Groups for years! ?I know to use it now. I had assumed it would require you to

RUD failure. For those who might not have heard the term before it's referred to as Rapid Unexplained (Unexpected/Unknown/Unscheduled) Disassembly (Decompression/Disembowlment) and so on.? I don't

Replace the MOV! They suffer internal damage whenever they clamp. Here's an insomnia curing paper on the subject; <

The wiring diagram for your controller can be found on LMS:

I have the FC350BJ motor controller on my Cummins mini-mill.? It is also used on mini-lathes so this applicable to this forum.? It's a second hand machine so I don't know its history.?

yea , the guy does real nice work . I wish I had half his patience .

I watched a lot of his build on the QC.? Pretty nice job IMO.? Way above my pay grade, LOL!?

A bit ago there was talk on QCGB's , this guy made one for a larger lathe & has several youtubes on his build . https://www.youtube.com/@TomMakeHere/videos

You have a lathe, no need for the grinder <jacquessavard@...> wrote:

pl what? do you? thing? about? use? a? grinder? to make a poley? whit? the nut is it a good? or bad? ?way? to fix? my problem some body? do that? before ? jack 47 71

plisse, voraite in french aiv' ry bodi antersdand. tink u

ok I think? I have x2? solution 1- make polly? whit? the? nut? very lilltle? poly? about 1 inch 2.-? the? shaft are abour 5/8? inch? and? I? have? ?poly of 1/2 inch? inside? but?

Add a few more pages on making * PISTON RINGS * MILLING IN A LATHE * MAKING GEARS IN A LATHE * BORE A ENGINE CASTING ON A LATHE * DRILLING A LONG BAR IN A LATHE * and more Dave *Part 1 of 2* *Part