Good Morning:
Finally received the new HS assembly from Homier, and carefully
swapped out the internals from the original. After installing
the "new" hs, and squaring it to the bed, I reinstalled the chuck,
and proceeded to chuck up a 1/2" 12L14 shaft to test the assembly.
Checking the hs/ts height, showed them to be in good alignment. Took
a .010" pass off the rod without holding the end in the ts, and even
taking a short cut 2" from the hs produced a taper. Am wondering if
the bed is twisted, or if I should just scrap this unit for a new
one. If anyone else has run across this situation, I would be
interested in hearing your thoughts/comments on correcting this
problem. Best regards, Nick
