Re: Three Jaw Chuck / Spindle Bore Opening
|
Just build yourself a momma boring bar, a few light?cuts is all it takes. That will even help with recentering the bore. Still much faster and cheaper than waiting for a reamer and paying for shipping/deposit.
It was rather expensive for a tool you'd only use once in your life. Maybe setting up such a program again would be a good idea, with a hefty deposit to borrow the tool.
Mike Taglieri?
On Sun, Nov 24, 2024, 11:09?PM davesmith1800 via <davesmith1= [email protected]> wrote: What was so special about the reamer?
?
Dave?
?
On Sun, Nov 24, 2024 at 04:20 PM, Roy wrote:
Opening the spindle bore is easy. LMS used to loan short shank reamers for that, until they didn't return. Doing it with a boring bar or adjustable reamer? is just a bit more tedious. (Did mine before the reamers vanished.)
?
Roy
|
