Wasn't thinking about that but st a minimum I'm pretty sure you're going to have to swap the half nut actuator shaft and maybe the apron. The nuts use a different engagement to the shaft and I don't know if the shaft will fit the Seig apron.?
I went with a electric lead screw a couple years ago. Back then it cost me a bit over 500 dollars for everything but has been great. I push buttons and can change from imperial threading to metric in seconds and also do feed in both.?
For me it was worth every penny as I do quite a bit of both imperial and metric single point threading.?
On Oct 18, 2024 at 12:44?PM -0400, thomasfkeefe@... <thomasfkeefe@...>, wrote:
Tony Smith, I suspect you are right about shipping. But I will keep that in mind. Thanks.
?
Tom
