开云体育

  1. 7x12MiniLathe
  2. Messages
Single Messages Topics Expanded

Re: how to.inspect.motor?

 

I hope check all of that before posting here.?
But still a good question.?
I use to think on troubleshooting? to check the plug was not need. Later I found from tech happens all time.

Dave?


On Sun, Jun 30, 2024 at 04:42 AM, paul mcclintic wrote:
On Fri, Jun 28, 2024 at 10:00 PM, Jon Rus wrote:
I'm going to offer that you may have a broken plastic gear inside the lathe.
A easy way to eliminate the gear train is to place the high/low gear lever in a vertical (neutral) position and see if the motor works O.K. You could also try turning the chuck by hand in both the hi and low gears to see what happens. If there are bad teeth you should feel that after a couple turns of the chuck.
Join [email protected] to automatically receive all group messages.