??? ??? Is it something that ya have to machine to a certain
tolerance or is just something that has to be pretty close to what
yer after ? If there's no tolerance needed drill a small hole in
the center & put a bolt through the hole & tighten it up
with a coupler nut . Then ya can put the coupler nut in the chuck
& go to town . Ya can even. use this method to get it close
& then remount it for the final machining? .
animal
On 6/11/24 3:54 PM, John Mattis wrote:
toggle quoted message
Show quoted text
With a live
ball bearing center run it up.agains?the work piece?to help
hole it in place.
You can also
put some holes in the part and boldt it to the face plate.
John Mattis
On Tue, Jun 11, 2024 at
2:56?PM David James via <davebjames=
[email protected]>
wrote:
I
have a 6" x 1" round piece of aluminum that I need to turn
into a flywheel for the model engine I am building. I was
thinking of using superglue to secure it to my faceplate as it
obviously does not fit in any of my chucks.
Any suggestions how to hold this or should I go looking for
someone with a bigger lathe.
Dave
Borneo
