开云体育

  1. 7x12MiniLathe
  2. Messages
Single Messages Topics Expanded

Re: 3-jaw largest bore?

 

I know? 7" and 8" mini lathes have seen? spindle hole just over ?" . I can even find larger
Do some mini lathes have smaller spindle hole?

Dave?


On Wed, Jun 5, 2024 at 08:17 AM, MikeK wrote:
By the way, I calculated that boring the spindle to 13/16" reduces the MT3 contact from 3" to 2.5", if that should matter to anyone.? Though I don't suspect many people use the spindle taper for much.? I rarely used my MT3 collets because most of them would get stuck and even using them required removing the motor cover to get the carriage in position.
Join [email protected] to automatically receive all group messages.