开云体育

Haven’t posted in a long time. Had my hf 4x6 saw for probably 15 years. Has been a pretty good saw, had to make special bushings and redo the front pivot to get it squared up, but it’s been

Howdy guys, I"ve been struggling with this table mod this afternoon.? ?The biggest challenges are: 1.? The hole which houses the original material stop rod is drilled really wonky!? ?I put a

E6000 is an adhesive that seems to bond anything with anything at ambient temperature conditions. The surfaces need to be clean and a small amount of adhesive is all that is needed. You can find it at

I have a long roll of adhesive backed yellow flexible ruler tape. I'll mail you 2 feet of it if you are ok with quarter inch graduations? Or 3 feet...? Or 4? But I need an address, email it to

If the stainless steel scale is magnetic (non Austenitic Stainless Steel types) you could put rear earth magnets in your iron angle piece. I have done this on my drill press so I can put in a 6" scale

I ;like the two sided tape idea. I bought some heavy duty double sided tape from McMaster Carr, to put on some chrome trim on my Jeep. That was in 2010, and the chrome is still there. I’m not sure

Thanks for all of your replies. Good point about better defining the problem? I want to make an extended table for my bandsaw.? ?I think I will make one very similar to the table defined by

??? ??? You can buy measuring tape with adhesive on it . https://www.amazon.com/s?k=adhesive+measuring+tape&crid=2BGXOH2EQYSZ2&sprefix=adhesibe+m%2Caps%2C243&ref=nb_sb_ss_sc_7_10 ??? ???

Is your application going to experience a wide temperature swing, or elevated temperature?? Much shear or pull force?? Does it have to be glued -- maybe? screw-down clamps would work?? Does the

You may want to look at high-strength marine epoxy.WheelerSent via the Samsung Galaxy S7 edge, an AT&T 4G LTE smartphone

3M 2216 2 part epoxy comes in gray or clear

I've done it, but the epoxy I used is no longer available (I got it as a sample about 15 years ago, and recently contacted the company because I couldn't find the product on their web site; turned

I'd use 24hr set epoxy. Scuff both sides with emery - jv wrote:

I want to glue a stainless steel scale to some carbon steel. ? ?Has anyone ever done this and if so, what adhesive did you use?

Jim, Sorry about that. My first post had an error in the URL. This <https://rick.sparber.org/PivotingJaw.pdf> should work. Plus I made a video

Not Found The requested URL was not found on this server. Additionally, a 404 Not Found error was encountered while trying to use an ErrorDocument to handle the request. Jim Land J&J

I got it, Rick. Thanks for the extra effort... -Bob [email protected]> wrote:

Here is the video ( https://www.youtube.com/watch?v=lWn6upY4c00 ).

Jack, Great idea. I’ll do it today. Rick

If a writer can make two sequels to ‘101 Uses For A Dead Cat’, you got it made!! :)