开云体育

Good that the new blade *did *fix your tracking problem Mark. I've read many times in wood bandsaw setup, that the positioning of the rear support roller is THE most important thing to set correctly

I was able to get my new blade tracking correctly, by paying a lot more attention to the initial setup for the idler wheel tilt mechanism.? My experience with this has shown that the shaft can be

I looked for the video but didn't find it. The method I described just makes setting up the guides a little easier. The horizontal position of the guides isn't super critical. I think mine is

This was my video. Yes "blade neutral" is an excellent way to describe this. To me this was a very logical and proven method of setting up the saw but I did confirm this with other saw manufacturers.

While browsing the web looking for 4x6 bandsaw alignment information I came across some references to "blade neutral" setup.? Basically, the guides should twist the blade but not push it away from

Can we drop by and help test the results??? -Dave

Lots of good DIY solutions here. I will admit to going commercial and just putting a longer hose on this brake bleeder. ( https://www.harborfreight.com/brake-fluid-bleeder-92924.html ) Taped the hose

??? ??? we will be waiting for your test report . ??? animal

I like the idea of using a pressure cooker...? but i would have to test the pressure cooker first by cooking some corned beef and cabbage.....

"The wine builds up pressure as it ferments ? I would think there's probably all sorts of safe-guards around that stuff." Yes there are safeguards.? Fermentation locks, basically the miniature

??? ??? I think I've seen Some that were? just big o-rings , WW' Graingers probably would have some or MSC ??? ??? animal

I think I got a large O-ring somewhere that just happened to fit.? No need for the weights- it's a vacuum chamber now.?? -Dave

If you have an Ace Hardware in your area, you can probably get a gasket from them. Also the weights and such. Bill in OKC William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by: SEMPER

I got a large, free pressure cooker a few years back and converted it to a vacuum chamber, but haven't used it for a real project yet.? I'm not sure what I used for a gasket.? I remember ordering

??? ??? It works real well . the reason I ran a tube to the bottom of the pot on the intake was so it was far enough from the suction side so I wouldn't be pumping oil all over the place . I

Need to add that you don't want to use much pressure to operate an elephant's head.? You don't want to split the seams of your container, destroy your expensive oak barrel or break your carboy if it

I like the idea of an old canner-pressure cooker, particularly since we were "gifted" with a couple of big ones (even though we already HAD one).? It seems that few use them these days.? At least

??? ??? I made something like that years ago using a old refrigerator compressor & thrift store pressure cooker? . Two holes in the top of the pressure? ,? one hooks up to the suction side of

Some time back I made an attachment for my shop vac that makes it easy to suck fluids like motor oil, gear oil and the like out of engines or other machinery.? Today I used it to suck the old gear

Thanks John