I have some 6" diameter scrap pistons I need to cut down. The cuts don't have to be pretty, I just need to hack the pistons up into chunks small enough for me to fit into my crucible so I can't melt them.
Even though the saw is listed as having a limit of 4" on round stock, I was wondering if anybody in the group has a work around. Maybe I can even get partial cuts without modifying the saw's pivot point? I was hoping to buy the saw tonight after work...
Thanks for any advice!
Yahoo! Groups Sponsor ADVERTISEMENT
To unsubscribe from this group, send an email to: 4x6bandsaw-unsubscribe@...
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
