开云体育

Made some progress-Photos

Need to do:

1-Wire electrics so it shut off with reset electrically like mill or lathe(Relay hold).

2-To obtain correct blade and start setting it to saw accurately, whatever it takes.

3-To make/design a heavy backstop for whole lid + bandsaw contraption to hold it the bandsaw vertically(Not the saw vertical like when you want to saw vertical), this is to hold the bandsaw vertically out of the way of compressor lid so the stainless tray can be used with lathe if needed, otherwise a small tray at end over this one is used.

4-Minor mods to compressor sides and painting.