I have a Grizzly 5 x 6, and with the blade removed, the idler has play all over the place. Pick a axis, it moves in any. It all goes away once you install the blade and tighten it, and has never been a problem in the 15+ years I’ve had the saw. ?
toggle quoted message
Show quoted text
On Nov 29, 2023, at 1:54 PM, Hettie Chom <hettiechom@...> wrote:
?
[Edited Message Follows]
Previously:
I made a bracket that swivel on top of compressor(Silenced) cabinet, of which in turn the top can open up like a car bonnet to access compressor parts to remove/repace when needed. The bansaw in turn can swivel up and vertical out of the way to reveal a
top stainless steel tray for use if needed.
Installing the bansaw(Refurbishing) on top of compressor:
Hi, back at the bandsaw. I would like to know about the play in the slave wheel alignment adjustment device. I understand the Tention of the blade adjustment and movement, as well as the Blade Tilt adjustment with fasteners "C & "B" in photo edited it swivel
around "A".
Problem:Play in Blade tilting device I cannot adjust, is it normal or a problem-?
<0_Play-AdjustableFrontWheelDevice.jpg>
What I don't understand is the amount of play up/down as indicated in purple when you pull up & down on pulley or pully shaft with pulley removed. I would say mine has excessive play here, which I cannot adjust. Before I make some mods with milling machine,
I would like to hear your opinion around this-?
Thankyou
Chris
