Re: Ideas For Holding Copper Water Pipe Fitting
|
re:?
?I have seen soft copper up to at least ?¡±,
I quit a job once after I had to install a 2" (soft copper) water service to a house by myself, I finally got the line installed but I had another 60' coil in the back of the truck that was all kinked and probable no longer usable.
Ralph
?
Well really, since this does not need to hold any pressure, you could go back to basics, and bang it up out of sheet copper.
Alternatively as well, you could use soft copper tubing, and bend it.?? I have seen soft copper up to at least ?¡±,
but I would doubt you need anything over ? for a drip line.
?
?
?
R James (Jim) Klessig P.E. | Senior Power Systems Engineer |
Electrical Reliability Services, VERTIV
jim.klessig@..., jim_klessig@...
1876 Gwin Rd, Mckinleyville | CA | 95519 | USA
| Cell (707) 497-9611 | eFax 614-410-0653
?
?
CONFIDENTIALITY NOTICE: This e-mail and any files transmitted with it are intended solely for the use of the individual or entity to whom they are addressed and may contain confidential
and privileged information protected by law. If you received this e-mail in error, any review, use, dissemination, distribution, or copying of the e-mail is strictly prohibited. Please notify the sender immediately by return e-mail and delete all copies from
your system.
|
