开云体育

Hi Florian, thank you for your suggestion! I investigate the S&H and if I find nothing I go and see.

Portamento or Glissando switch doesn't change the result. But?look below (we are on the S&H board outputs). One is terminal K3 and the other is K4, the one with the problem .. guess which one is!). I

My suspect is the 4016 (IC10 on KAS) Am 16.09.22 um 08:35 schrieb Joachim Milson:

Hi Bof bof, That's strange indeed. If you set the Portamento-Glissando rocker switch to Glissando while keeping the Portamento-Glissando white slider to short, do you get stepwise variations or is it

Hi Joachim, thanks for your answer. Yes, the Portamento/Glissando is off (all the way down),?also because I believe that if this were not the case the behavior would be on all voices and not only on

Hi, Do you get both upwards and downwards portamento? Also can you confirm that the Portamento-Glissando white slider is set all the way down to Short (which is what turns the Portamento-Glissando

Hi everyone, I hope you are all well. I have strange behavior on my CS-80. On the fourth voice (therefore cascading on both M14 and M24 cards) there is a portamento that occurs as soon as I press the

Thank you very much to you both (Gustavo and Scott), this is very helpful. This should bring back my CS80 to fully working condition. Martin

Martin: For PH1, PH2, and PH3 on the PRA board, the *Xvive Vactrol VTL5C3* is a drop-in replacement. Its response curve is the same as original working parts on the PRA card according to my tests

Hi Martin, how told that was Mr. Scott Rodriguez, I only agreed with his comment. Anyway let me tell you that if the Diode that illuminates the photo resistor in PH1, PH2 or PH3 opens up, that is

Greetings to all, Since the topic is including problems on the PRA board (which mine has) I thought I would ask. Gustavo when you write: “If one or both of the sensors in the CS-80 are

Hi, Could anyone provide the correct style/base number for the 24v 5w bulb in this expression pedal? It seems like most of the 24V 5W are huge. Many indicator lamps have a standard four digit number

Gustavo.: I was trying to assist Mathias with his debugging efforts. And right you are, the preamp card is called out as PRA, not PRE, my mistake. geegrinovero@...> wrote:

Hello Scott, I do not know if you are adressing to Mathias or me.... Just in case it is me, I have the original Foot Controller with Lamp/Photoresistor. and the board that you referenced it is PRA

Do you have a Yamaha FC7 expression pedal you could use to check out the circuit? They work ok with the CS-80, but the range is a bit biased compared to the original light-operated unit. That will at

Hello Mathias, in a couple of weeks I will be at the place where it is stored my CS-80. Then I will be able to take note of the Foot Controller circuit and pass you some information to verify

Hi Gustavo, Thank you for the information! I did open up the pedal and good news: the bulb is working when plugged in and gives off light. I don't know how to test the photo-resistor, however. Any

Thanks David, this was amazing! Best, Mathias

Hi all! I ran across this Led Zeppelin video last night about In Through The Out Door. It has a surprising amount about the wonderful Dream Machine including the ELP and Abba connections. This

No problem Some else wants it. It will be good see it get used. Best of luck solving your problem. From: [email protected] <[email protected]> on behalf of Mathias Tjonn