开云体育

Hey Mike, Ebay would be your fasted bet. Buy the FP301 power supply w/speaker for $99 or the cable for $65. Michael

Hello Mike, I also purchased a? 301 without the cable (or power supply) in the past. There used to be a guy on qth.com who sold power cables for various vintage (and not so vintage) radios. I

That should be LSB crystal….damm spell checker! [email protected]> wrote:

The lab crystal may not be starting reliably….old age….may need to try varying the capacitors in its circuit. Dave.

Hi I have a FT-301D from new. Lately sometime I use it the LSB setting is dead in RX and TX on all bands USB is ok AM is ok. I also think CW is dead in RX but seems ok in TX. Then another day it works

Thanks for sharing this FT-301d restore post. I have a FT-301 under the workbench that needs restoration and learning alot from Eric Sorensen's content. Mike Peace

I have a 500 Hz CW filter that has quit working due to age. It failed to pass the CW Tune signal so I took it out of the FT-301. It is an International Crystals filter.

http://esorensen.com/yeasu-ft301d-restore-part-1/

Where is this blog? To: "Felsummers" <felsummers@...>, "yaesuft301d" <[email protected]> Sent: Saturday, August 5, 2023 7:28:15 AM Subject: Re: [yaesuft301d] Low Tune power FIX

Op do 29 jun. 2023 om 22:21 schreef Forest (Gene) Summers < felsummers@...> > I followed this helpful blog, I removed C428 and was able to get 100+ > Watts of CW output on my FT-301D. Note:

Hello, I just purchased a rough FT-301 to restore, it's missing the power connector cable. Anyone have a power connector with cable for sale? I can pay by Venmo or Zelle. Shipping to Springfield,

Hi, Drifting out of spec xtals are typical, Ive had to do the same on others boards as well. This is good input for others trying to fix their FT301s, thanks. There is a company in the Netherlands

I followed this helpful blog, I removed C428 and was able to get 100+ Watts of CW output on my FT-301D. ?Before removing C428, I was getting about 5W tune power on 10m, 15W on 15m, 35W on 20m, 30W on

you might want to sweep your crystal filters also. I have read on the internet somewhere that they also age and change frequency. I have to many projects going on and cant give you any other

My manual did have an obvious mistake in the alignment instructions, but in truth I think it was a typo. D. wrote:

I’ve had the same issues with the USB and LSB xtals had to change caps to get them back inline. Any one know of a xtal manufacturer that can makes these HC49U. Back in the day I used Jan crystal.

Hi All, Has anyone seen manuals that change the calibration procedure based on new versions of boards installed? Do all manuals have the same calibration instructions. I have older 301Ds with

This company (Elcon) also sells a complete replacement kit for the FT-301D display in case anyone is interested. 73, Bob, K5INW

Thank you Roland, I will follow that up. All the seasons best. Dave….G4DAX.

You can get them here. https://shop.elcon.ch/yaesu/schnappverschlussniete-zu-ft-301.htm