开云体育

I have not measured the voltage in my unit, but if it should be 60.2V, then 55V is absolutely too low to be correct at least. If the specs would say 60V instead of 60.2V, then 55V might be about

Hi EP has?good advice about your problem. Also, It sounds to me like your M12 stuck in start-up. This points to the main processor board.? I would start by carefully disconnecting and reconnecting

thanks for that, ill try it. ill check the 6809. does 60.2vdc sound close enough for the 55vdc? all the other voltages read properly.

Hi, The 9V AC is used only for the filaments of the tubes and is not regulated. So, it possible that you have a probleme with one of the display. Disconnect the cable from the panel board to the

Hi all, im hoping someone might have some ideas/leads for me. upon turning on, my M12 is not producing sound, most red LED's are solid on, and the displays are blank. if i hold the "clear" button

HI I missed the original email about where to get the encoders.. could someone please forward it to me? thanks analog-jeff

They can also be ordered from Farnell but theyll ship from the US and cost more. WT

Hi James, That is indeed excellent news. Thanks for the detailed write-up. I happen to have an incomplete Mouser order open in my browser, so I have chucked a dozen of your encoders in there as well.

Rejoice! Rejoice! Rejoice! I have found an extremely suitable encoder for replacing cranky/dead ones on the Xpander. They are relatively new from Bourns. The part number you want is PEC09-2325K-N0015.

http://shop.ebay.com/synth-parts/m.html

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the xpantastic group. File : /Patch Banks/XplorerRandomizerVolume1.zip Uploaded by :

Hi, I have a few more of these chips in stock now. Thanks, Doug synthparts.com

Wow thanks for your reply. I'll look into that, meanwhile this may also help me... http://www.cykong.com/CubaseSX/SXpanels-Tips4.htm Nick

1) The easy way: Use Pedal 1 or 2 as modulation sources: Go to Master Page/Midi/Ctrl and assign a control change number to Pedal 1 or Pedal 2. In your tone, set Pedal 1 or 2 as modulation source of

There's a remote control program on this page for the Peavey 1600/1600X MIDI controller > Xpander, and Resonance IS one of the assignments, so it seems to be doable.

Take a look at the Xpander MIDI Specs and Programming at http://launch.groups.yahoo.com/group/xpantastic/files/Documents/ Maybe somebody could give you a more direct answer, but in general, it is also

Hello I'm new to the xpander (and synthesizers in general) and was wondering if someone could help with a little advice. I have an evolution mks-149 that has lots of assignable knobs that i would like

Eventually a question for the Kurzweil forum @ Sonicmatter http://community.sonikmatter.com/forums/ Sorry, I cant help,- no poly AT keyboard available here. Am 25.09.2010 04:08, schrieb r_j_d_2.phila:

wow, this is wierd. i JUST came here to ask the same thing. well, technically, on a matrix 12, but yea..... so any ideas? i am told that the midiboard can be set up so that 16 midi channels can each