开云体育

Thanks Captain, good advice. So I tried a full reset (holding "clear" down at power up) but same problem. (Which I discovered BTW, leaves patches intact, but wipes master settings.) Each time I ran a

could it be something set in the GROUP pages? You know, the section where you can set up multitimbral routing and splits and so on? vaguely remember this on my m12, and it was caused by overlapping

On my Xpander, each pair of oscillators are always a bit out of tune with each other. The amount of detuning is different on each voice, but consistent per voice, being off by +/-3 cents. The tuning

Maplin order code: GL88V You get 10 fuses, which should last at least 10 years of mains surges. Right now, you can only pick up instore in the UK. But this info might help someone regardless. More

Your Welcome, Always glad to help Karl

Karl Schmeer shire03@... [xpantastic] wrote: Wow you're totally right! All but voice 5 was on. I did as you said and it tunes now. There I was thinking I'd trashed a $4500 synth! Thanks

Hi Check and see if all the voices are turned off.( Page two of Master page)If they are all off, it will cause the problem you are seeing.Check this first, then we can go from there. Best Luck Karl

it would probably whatever circuit provides the voltage that tells the computer that the voice checks out? ?NEW ALLIANCE EAST!!!! -------------------------------------- New Alliance East?- Mastering

Hi, My Xpander conked out today, and now when you tune, it just whizzes the numbers 1-6 past mega fast, and therefore doesn't tune properly. I'm a bit upset to lose this expensive synth. I tried all

ok many thanks, i'll start by swapping the C449 cap and see how I get on.

Hi, Yes, you are correct. That cap tends to fail.? I bought a hundred of them some time back, but have?only had to replace?2 or 3 of them, over the years.? The part in your link should

Hi all, so I discovered this week that Voice 4 on my Xpander has died and is skipping when playing. I don't believe its a dead voice chip as I switched the chips and couldn't replicate the issue on

The @@@@@@@@ or %%%%%%% in the display is usually the PSU needing a refurbish (caps), or one of the ribbon cables needing a re-seat, and is common across the range of 6/12/Xpandr. Same for the all

Hey Odds are real good it's a battary issue, But being the machine is +20 yrs old the caps could easily need replacing. While you are replacing the battary it would be a good idea to re-seat all the

Again I cannot claim that our symptoms match up and mine was a Matrix 12 but the symptoms changes form bot up to boot up and all went away on a battery repalcement xpantastic@...> wrote:

Hopefully it is. Though looking at the schematics, I'm not totally sure why the battery failing would quite cause this. I could see that with it failing, some of the RAM bits would become corrupted;

I had a simliar-not identical but I got the "reset message " etc experience last year. I got sound but it was odd sound . It did turn out to be the battery. Hope that's the case with yours as it was

Hey there, My xpander - which I got last year - has started doing odd behaviour, and I just want to float it past you guys to see if it is what I hope it is; or if not, help to narrow it down. I was

I think you have the chain mode enabled. Which allows one to sequence the patches, single or multi. Look in page two of the master page Best Karl --------------------------------------------

I am not sure how this has happened but when I am using my Matrix 12 in the single patch and I wish to go the the next patch (for example #23 to #24 or #25), the patch jumps to a multi patch. I can