¿ªÔÆÌåÓý

Contact Clavia, their Nord synthesizers use similar looking buttons, albeit smaller. ?I'm sure the same manufacturer makes the bigger Xpander/M-12 button keytops. ? I did see those online a little

Great news! Thank you guys! Tiitu

Yes ! Thats the right ones !!! I replaced all in my XPander. merry x-mas too PeWe Am 20.12.2014 um 15:27 schrieb geebeex@... [xpantastic]:

Syntaur just got tons of OB parts including panel switches... Check it out on AH.

Sam Mims of Syntaur just yesterday posted on the Analog Heaven mailing list that they now have all the old stock of parts from Oberheim/Gibson. I'd definitely check there to see if he has any. Seth

Hi, If you are speaking about front panel switches, see this post: https://groups.yahoo.com/neo/groups/xpantastic/conversations/messages/924

Hi, Does anybody know, if there are anywhere available spare Xpander buttons, originals or compatible? I might be even willing to trade a CEM3374 or a display for buttons - if sale is not an option.

Hi Matt, What is the difference between B and C series? Tiitu

Hi, It's a well built machine, removing the six screws on the ends allows you to lift the front panel of the xpander up. The circuit board that the buttons are attached to, are actually on a special

Hi all, looking to trade or sell a few CEMs--I've got 9 new old stock 3372 B series chips; I need 3 C series. I would trade 3 for 3 C series and sell the rest if possible. If someone wants to buy all

I had the same issue on mine. Rather than opening it up, I simply took a razor blade and shaved off the edge of the button hole on the case until it didn't stick. This sounds bad, but the holes are

i have a xpander , not hard to open..?they are the big main board, psu board , and other board for memory, control on cover ..pcb board are hold and fragile, some component are fragilising by the

It sounds as if the front panel is slightly out of line with its switch holes. Just loosen all the panel mounting nuts on the inside, just enough to allow a little free movement of the pcb, and

For photos inside, see: https://groups.yahoo.com/neo/groups/xpantastic/files/Pictures https://groups.yahoo.com/neo/groups/xpantastic/files/Pictures/

Be carefull ! 1st try to reseat the circuit boards under the frontpanel,- if this doesn?t help, here?s my story: It?s possibly the plastic surface w/ all the printouts which is glued to the

Same!! I too am having one of my button sticking in the same manner and had considered the same remedy. Any suggestions would be awesome. S

Hi all, Im looking for suggestions on how to fix the sticking buttons on my Xpander. When pressed down, they stay down, and can only be brought back up by scratching at their sides, or, gasp, tugging

Matrix's and Xpander OS goes a bit bonkers at times. Try a complete reset. It certainly helped me when I had problems with tuning/processor malfunction errors and the like. You might have to back up

I booted up my M12 tonight and can't get anything to pass tuning. Any ideas what I should check for? Likely a failed logic chip inside, but how would I debug?

Was the basttery- I replaced with one of these and all is well again, :) CR17335SE LFU - FDK 3V CR 17335SE, 2/3A, U-L?tfahnen jetzt f¨¹r nur 4,30 € bei reichelt elektronik