开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. Xiegu-X6100
  2. Topics

X6100 - Corrupted base firmware

 

Have somehow corrupted my base software.
Display shows but radio is dead.
Have tried re-installing various firmware versions no good.
Thanks for any suggestions
?
?
?
?
?
?
?
 

I just repaired a 6100 with the same issue and it was a bad STM32 chip. I ended up swapping the main board for the customer.
?
?
JJ
W9JES Radio & Electronics
 

开云体育

Hi JJ, Thanks for the reply.? I think I may be in the same boat with a blown chip.

I’m in NZ.

Where did you source the new mother board ?

Thanks

?

Simon Jones

simon@...

027 5482833

?

From: [email protected] <[email protected]> On Behalf Of JJ - W9JES
Sent: 25 December 2024 02:25 AM
To: [email protected]
Subject: Re: [xiegu-x6100] X6100 - Corrupted base firmware

?

I just repaired a 6100 with the same issue and it was a bad STM32 chip. I ended up swapping the main board for the customer.

?

?

JJ

W9JES Radio & Electronics
 
Edited

Simon?? via ST software could you not load a demo file to the STM32.If that loads ok.Then try to load the X6100 firmware.
I thought there was an option to zero the STM32. Using ST-Link.
This may be of interest.
?
in Q900 radio's in early firmware you used a loader to much like ST-Link to load to the STM32.
It worth trying to recover via ST-Link, give it a go nothing to lose really.

1 - 4 of 4