#FLRIG 2.0.05 with IC-7300 custom command? #flrig
|
Anders Georgsson
I am trying to figure out how I can use FLRIGs to switch my spectrum scope between center/fixed/scroll-C and SCROLL-F mode. Has anyone figured out how to do this?
?
According to the full manual - page 19-14, you'd use the "27" command like this:
?But if I send 27 0000 or 27 001, it doesn't change?
?
Any suggestions or advice is greatly appreciated!
?
--Anders Georgsson
KZ4JN/WSDF851 |
开云体育Shouldn't the "27" be the last digits in the command, not the first? Ken W7EKB Sent via the Samsung Galaxy S21 5G, an AT&T 5G smartphone -------- Original message -------- From: "Anders Georgsson via groups.io" <anders.georgsson@...> Date: 3/8/25 09:53 (GMT-08:00) Subject: [winfldigi] #FLRIG 2.0.05 with IC-7300 custom command? I am trying to figure out how I can use FLRIGs to switch my spectrum scope between center/fixed/scroll-C and SCROLL-F mode. Has anyone figured out how to do this?
?
According to the full manual - page 19-14, you'd use the "27" command like this:
?But if I send 27 0000 or 27 001, it doesn't change?
?
Any suggestions or advice is greatly appreciated!
?
--Anders Georgsson
KZ4JN/WSDF851-- Ken Gordon W7EKB |
|
Anders Georgsson
Good question.. I'm trying to figure it out by using the "Send command" in the configuration screen. it has the "ICOM Pre" and "ICOM Post"?
which are set as "xFE xFE x94 xE0" and "xFD " - so i'm trying to send "xFE xFE x94 xE0 x27 x1C x01 xFD" and "xFE xFE x94 xE0 x27 x1C x02 xFD" which should switch between Center and Fixed? ?
?
I usually press the <CENT/FIX> button on the screen while I am doing CW to see where others are having QSOs on the band I am on - then once I scroll near the frequency, I press the <CENT/FIX> again to see the frequencies closer... THAT is the function I am trying to imitate.
|