Re: IC7300 CW with FlDigi 4.2.06
|
Restart. Yes. It's in the document. Making changes to the rig control especially and that's where most of the problems occur. best, jim/K2JJK On Tue, Mar 18, 2025 at 2:38?PM Anders Georgsson via <anders.georgsson= [email protected]> wrote:
When in doubt - restart ?? IT rule #2 ?? Yes - i've tried that as well.
On Tue, Mar 18, 2025 at 12:32?PM Jean Christophe Barbera via <jc-barbera= [email protected]> wrote: I'm new to this software. I sometimes have difficulties. I've noticed that it's sometimes necessary to close the software for changes to take effect.
Jean-Christophe BARB?RA Le 18 mars 2025 à 16:12, Anders Georgsson via <anders.georgsson=[email protected]> a écrit?:
? Hmm - did have <# TXRSID:on> in my macro (which should mean that it isn't executed, right?) but I removed that line all together and it is still behaving this way.
The only button I have turned on at the top right in FlDigi is "Spot"...
?
I even tried turning that off but it still toggling the between TX/RX during the transmission of code...
?
I am not sure if I mentioned this in my original post but I'm using FLRIG to control my rig (so I can control it remotely) - if I use it's CW Keyer - the radio pulses the signal rather than keeping the transmitter on and playing the tone thru the integrated sound card as well?
?
?
--
Anders Georgsson
(352)316-0258 cell? KZ4JN/WSDF851
|
