These are the documents you
need for setting up the 7100 either for audio FSK or keyed FSK:
fldigi can then be used for
sending characters to the program flrig which in turn
generates the correct FSK keying signals to send to the 7100.
I would suggest you first
try using the 7100 in USB-D and sending the audio FSK to the
transceiver.? Be careful not to overdrive the audio, just like
you would if operating PSK-31 or any other digital mode.? RTTY
is simply another digital mode.
David, W1HKJ
On 10/11/24 20:22, Adrian Fewster
wrote:
toggle quoted message
Show quoted text
AFAIK, Fldigi only use's afsk for RTTY which means radio should
be in a suitable ssb mode.
Data-A or Data-L or USB or LSB, depending on program REV
selection for space mark polarity.
RTTY here is used for FSK, extFSK use, with RTS keying.
73
vk4tux
On 12/10/24 04:32, Don Rolph via
groups.io wrote:
Are you getting PTT signal sent (radio should go
into transmit mode)?
Are you putting out?any power (use power meter option on
IC-7100)?
Initially I could receive?but not send also.
I found the following helpful and when I reset according
to these instructions?all worked.:
Note: I had trouble with autobaud on CAT and a fixed
setting of 19200 seems to have resolved this issue.
On Fri, Oct 11, 2024 at
10:53?AM mike isakson via <w7xh.mike=
[email protected]>
wrote:
Call sign W7XH
I am hoping to ask the group about a problem I am
having with my IC-7100 sending a continuous carrier . I
do not get? a diddle. I have tried both 4.1.20 and
4.2.05 fldigi and flrig 1.4.2 and 2.0.05.
I? have installed IC 7100 usb drivers and am
connected with a usb-a cable. The radio is set to RTTY .
I have rig control with flrig,fldigi, and N3FJP
operation. If I send a rtty message directly from the
radio, fldigi decodes it perfectly. I am just not able
to send.
73 Mike W7XH
--
Dave