On Jul 15, 2024, at 11:31, Bob - KG5SQJ <bobnmarji@...> wrote:

?

For our newest Amateur Radio Operators that have recently passed their first Ham License Exam and joined the hobby (and/or others who are interested), the Common Amateur Radio Repeater Terms information below was provided by Texas State RACES point of contact, SRO Roy Walker (WA5YZD).?

?

It would have been very useful to me if someone had provided this information when I first became a Ham Operator.? ?

?

73,

Bob – KG5SQJ

?

From: [email protected] <[email protected]> On Behalf Of Roy Walker WA5YZD SRO 1A
Sent: Monday, July 15, 2024 8:21 AM
To: [email protected]
Subject: Re: [TexasRACES] MISC

?

Common Amateur Radio Repeater Terms

Chances are your first QSO (communication) will happen on a local VHF or UHF repeater using a?. Repeaters have their own terminology, like courtesy beep, DTMF, and split. However, this split doesn’t involve bananas and courtesy beeps shouldn’t be confused with roger beeps used by CBers. You’ve probably used DTMF before, but in a different context—on your phone.

Here are some repeater terms you may encounter while you’re on the radio.

A Glossary of Ham Radio Repeater Terms

***

·? Break: A word used to interrupt a conversation on a repeater to indicate there’s an emergency. You should say “break, break, break” to be sure you’re heard. It’s not used to join a conversation.

·? Deviation: This refers to the change in the carrier frequency of an FM transmitter produced by the modulating signal. If you’re told your transceiver is over-deviating, talk farther away from the microphone to avoid distortion.

·? Double: Two or more stations transmitting simultaneously on the same frequency, often without knowing it. The one with the strongest signal wins, but if it’s a tie, neither is heard.

·? Full Quieting:?This term usually signifies a good quality signal on a repeater or FM transmission. It means that your signal is clear, free of static, and easily readable.

·? Half-Duplex: Radio communication using two frequencies, one for receive and one for transmit—one radio at a time.

·? Hang Time: This is a cure for the double. Waiting briefly between transmissions allows smooth transitions. It also gives others a chance to join in the conversation.

·? Kerchunking: You have an HT, but will it reach the local repeater? Turning it on, you briefly hit the transmit button and hear a tone in response. Satisfied, you try it again—and again. That’s kerchunking—keying up a repeater just because you can. It can really become annoying to anyone monitoring the frequency. The proper way is to say your call sign when you transmit, or something like “KE8XYZ, testing.” I even heard of one repeater that reportedly responds with “kerchunk” if it is keyed and no audio is detected.

·? Machine: This refers to the repeater system itself. You might hear something like, “The 37/97 machine has the best coverage in the county.”

·? Offset/Split: If the repeater output is 146.840 MHz, the input or the frequency the repeater receiver listens on is 146.240 MHz (600 kHz below 146.840 MHz). The offset prevents transmit and receive signals interfering with each other at the repeater.

o??? If you’re tuned to 146.840 MHz, when you push the mic button your radio automatically transmits on 146.240 MHz, 600 kHz down from 146.840. When you release the mic button, your radio switches back to 146.840 MHz to listen on the repeater’s output frequency. Confused? No worries—virtually all ham radios sold today set the offset automatically.

·? Open Repeater: A repeater that may be used by any licensed ham radio operator is considered open. Closed repeaters are restricted to exclusive groups, such as members of a club.

·? PL Tone: PL (private line) tones or CTCSS (continuous tone-coded squelch system) tones are sub-audible tones of 300 Hz and below that are transmitted and detected by radios and repeaters. The tone is transmitted when you talk, and the repeater lets you through if you’re using the correct tone. It’s used to prevent people accidentally keying up on a repeater frequency or a repeater interfering with another repeater during a band opening.

·? Repeater Directory: It’s a publication that lists repeaters in the U.S., Canada, and other areas.??(below). You can also find directories on the Internet from many sources. Do a repeater directory search to locate them.

·? Simplex: This is communication where hams receive and transmit on the same frequency without using the repeater. It’s also called talk around. You can do this to avoid tying up the repeater, especially if you’re not far apart.

·? Time Out: No, you don’t have to sit in the corner. This happens when a person talks too long and the repeater time-out timer (TOT) temporarily shuts down the transmitter. There will be a short pause, then the repeater will reset and the conversation continues.

?

Hello Matt and Bob,

?

We need some help on the Blazin’ Saddle 75 Bike Ride, scheduled for 3 August 2024. Information about the ride is in the attached PDF. They can signup at . Anyone signing up for SAG Wagon will need the ability to transport bikes and riders. Additional information about the ride is available at .

?

Anyone who signs up, needs to email their T-Shirt Sizes to me, at nk5h.tx@....

?

73,

Tom Hyde NK5H

President, Hood County ARC

Mobile: 214-794-9175

Email: nk5h@...

10329 Ravenswood Rd.

Granbury, TX 76049

?

?

Common Amateur Radio Repeater Terms

Chances are your first QSO (communication) will happen on a local VHF or UHF repeater using a?. Repeaters have their own terminology, like courtesy beep, DTMF, and split. However, this split doesn’t involve bananas and courtesy beeps shouldn’t be confused with roger beeps used by CBers. You’ve probably used DTMF before, but in a different context—on your phone.

Here are some repeater terms you may encounter while you’re on the radio.

A Glossary of Ham Radio Repeater Terms

***

·? Break: A word used to interrupt a conversation on a repeater to indicate there’s an emergency. You should say “break, break, break” to be sure you’re heard. It’s not used to join a conversation.

·? Deviation: This refers to the change in the carrier frequency of an FM transmitter produced by the modulating signal. If you’re told your transceiver is over-deviating, talk farther away from the microphone to avoid distortion.

·? Double: Two or more stations transmitting simultaneously on the same frequency, often without knowing it. The one with the strongest signal wins, but if it’s a tie, neither is heard.

·? Full Quieting:?This term usually signifies a good quality signal on a repeater or FM transmission. It means that your signal is clear, free of static, and easily readable.

·? Half-Duplex: Radio communication using two frequencies, one for receive and one for transmit—one radio at a time.

·? Hang Time: This is a cure for the double. Waiting briefly between transmissions allows smooth transitions. It also gives others a chance to join in the conversation.

·? Kerchunking: You have an HT, but will it reach the local repeater? Turning it on, you briefly hit the transmit button and hear a tone in response. Satisfied, you try it again—and again. That’s kerchunking—keying up a repeater just because you can. It can really become annoying to anyone monitoring the frequency. The proper way is to say your call sign when you transmit, or something like “KE8XYZ, testing.” I even heard of one repeater that reportedly responds with “kerchunk” if it is keyed and no audio is detected.

·? Machine: This refers to the repeater system itself. You might hear something like, “The 37/97 machine has the best coverage in the county.”

·? Offset/Split: If the repeater output is 146.840 MHz, the input or the frequency the repeater receiver listens on is 146.240 MHz (600 kHz below 146.840 MHz). The offset prevents transmit and receive signals interfering with each other at the repeater.

o??? If you’re tuned to 146.840 MHz, when you push the mic button your radio automatically transmits on 146.240 MHz, 600 kHz down from 146.840. When you release the mic button, your radio switches back to 146.840 MHz to listen on the repeater’s output frequency. Confused? No worries—virtually all ham radios sold today set the offset automatically.

·? Open Repeater: A repeater that may be used by any licensed ham radio operator is considered open. Closed repeaters are restricted to exclusive groups, such as members of a club.

·? PL Tone: PL (private line) tones or CTCSS (continuous tone-coded squelch system) tones are sub-audible tones of 300 Hz and below that are transmitted and detected by radios and repeaters. The tone is transmitted when you talk, and the repeater lets you through if you’re using the correct tone. It’s used to prevent people accidentally keying up on a repeater frequency or a repeater interfering with another repeater during a band opening.

·? Repeater Directory: It’s a publication that lists repeaters in the U.S., Canada, and other areas.??(below). You can also find directories on the Internet from many sources. Do a repeater directory search to locate them.

·? Simplex: This is communication where hams receive and transmit on the same frequency without using the repeater. It’s also called talk around. You can do this to avoid tying up the repeater, especially if you’re not far apart.

·? Time Out: No, you don’t have to sit in the corner. This happens when a person talks too long and the repeater time-out timer (TOT) temporarily shuts down the transmitter. There will be a short pause, then the repeater will reset and the conversation continues.

?

FYI – Radioddity.com is running a 15% off Sitewide Sale with free shipping on orders over $99.99.? Their TYT TH-9800 Quad Band Mobile radio (same radio I’ve used in my truck for 6 years) is also on sale at a starting price of $189.99 and with the 15% off of that puts the total cost at $161.50.? This sale also reduces the regular $259.99 cost of the QT60 10 Meter all-mode 60W radio down to $221.00.? IMHO, the QT-60 is a decent, lower-cost HF Radio for Technician License holders that are only allowed to use SSB communications on the 10 Meter Band.

?

73,

Bob – KG5SQJ

?

?

?

?

David Landers (N1DVM) asked me a wise and a very valid question “... what is better about this battery vs some of the ones touted a lot that are ~30% cheaper? PowerQueen, Miady, etc.”.

Thanks for the opportunity to clarify why I believe the AOLithium 100aH BlueTooth LiFePO4 battery is a high quality product.?

?

First, it took me many years before I became a believer in the old adage that "Ya usually git whatcha pay fer!" and I ceased making my product purchase decisions based on price alone many years ago.? So far, I have never regretted paying a higher price for a higher quality product.? That doesn’t mean I don’t buy cheap stuff from time to time, but only when it meets the need.

?

I haven’t purchased a 100aH Power Queen or a 100aH Miady LiFePO4 battery so I have no personal experience with those brands; they may or may not be worth that lower price.? I have heard from a Ham that his 200aH Power Queen LiFePO4 batteries work well for his solar system.? So far, the four AOLithium 100aH BlueTooth batteries I purchased periodically over the past three years have always performed very well for my needs.

?

What I found "better" about the AOLithium LiFePO4 battery (beyond the obvious BlueTooth capability) is based on multiple reviews done by two different guys who produced YouTube videos regarding how they tested the product, took it apart and evaluated how well it was manufactured.

The first video was done by Will Prowse -

If you have never heard of Will Prowse and you would like to learn about off-grid solar systems, check out Will’s YouTube Channel -

?

Here is the link to the 2nd video review of the AOLithium 100aH Bluetooth battery -

And the link to his follow-up update stating that the Continuous 200A Discharge originally stated for this battery is actually only 3 Minutes -

?

Hopefully this answers the question and is additionally useful information.

?

73,

Bob – KG5SQJ

?

-----Original Message-----
From: [email protected] <[email protected]> On Behalf Of David via groups.io
Sent: Wednesday, June 19, 2024 6:15 AM
To: Bob - KG5SQJ <bobnmarji@...>; [email protected]
Subject: Re: [North-Texas-NVIS-Net] FYI - AOLithium 100aH LiFePO4 Lithium Battery Price Significantly Reduced PLUS 3% Off That Price June 18th to June 20th

?

Thanks for the recommendation.

?

I'm not super knowledgeable about lifepo4... what is better about this battery vs some of the ones touted a lot that are ~30% cheaper? PowerQueen, Miady, etc.

?

--

DAVID

N1DVM

CARROLLTON

?

?

?

If you are interested in buying a high quality 100aH LiFePO4 lithium battery, AOLithium has not only reduced their regular price from $583.99 to $349.00 but they are also currently running a short, 3-Day sale offering an additional 3% off of that price (free shipping).

This AOLithium 100aH battery is the model I use for Field Day events. -

?

Don’t forget to also order a charger for it if you don’t already have a LiFePO4 battery charger – This is also on sale ($49.99 – 3%)

?

AoLithium also sells a 100aH LiFePO4 battery without Blue Tooth that is on sale for $199.00 but they are currently sold out -

?

And no, I don’t have any monetary association with AOLithium.

?

73,

Bob – KG5SQJ