开云体育

I was sent several Walthers single crossovers. ?For signaling purposes do I need to cut gaps on the crossover section? ?If so, where?

?

VH

I haven't seen one of these turnouts to examine, but I would think it would already be gapped.? To be sure, test it with a digital multimeter.

?

You specifically referred to signaling.? So I presume you already have it working on your layout.? If you do, you are probably good to go.? If the signaling implementation you are planning requires gaps in places not already provided by Walthers, then you may have to do more.? Let your digital multimeter tell you what you need to know.

?

Allan Gartner

Wiring for DCC