开云体育

I got some answers earlier. I just don't quite get it yet. If anybody
can help me again, my DT100 is showing FF on the right hand side of the
throttle. This of course, makes it unable to key in a loco address. I
know the FF means the DCS100 is full. Can someone help me by telling me
HOW to do away with the FF and get it back to normal? What I really
need, is some detail steps on how to do this. I looked all over the
book and cannot find the answer. Who ever can help me through this
trauma; this will be most appreciated, please send me an e-mail at
lhannahan@.... Thanks in advance.

If you want a detailed answer, you are going to have to wait about a
week and half when I have more time. Here is what you need to do.

You need to clear the Chief's slots. If my memory serves me right,
check options 32 thru 36. One of them is labeled something like
clear roster, slots, or locos. If you are not using routes and
things, it won't hurt to clear them all.

To clear an option, flip the DCS100 to OPT. Using your DT100, hit
mode until a black dot appears under Switch. Then dial up the option
you want to change. Then press the c or t key. If you are not sure
whether to hit c or t, hit them both (one at a time).

Hopefully, this is enough info for you. Otherwise, you will need to
wait until I am done with final exams.

If you need to be stepped through it before I finish exams next week,
call Digitrax tech support.

Note: Normally, your slots should not get full. Be sure to dispatch
your locomotives before removing the battery from your throttle.
Dispatching clears the loco from the slot.

Allan