Hello All
I have a reverse Loop and I setup two blocks in the Loop for signaling?
All trains can run in either direction thru the loop with now problem.
Today on the two feeders I connected my NCE BD20's to my NCE AIU-01
I was trying to setup the turnout also with another pair of BD20's? So when I did that I put a cut in one of the rails and ran a feeder down thru the BD20 and connected to my DCC Track Bus Line.
When I put the cut in the rail I had to add an additional pair of feeders just pass the cut so that the rails would have current.
?
That all worked? until today.? When I connected the BD20 to the AIU-01 I lost power to the Loop only has 2.3 volts.
after some time I decided to remove the extra feeders from the equation? ?So now I only have two wires for each feeder to the BD20.
Still no power?
So I removed the BD20's from the AIU-01 and still had no power?
I then Added back the extra feeders to the terminal block that connects to the AR Device? A Dual Frog Juicer by Tam Valley
So the question I have is
How to you wire a reverse loop so I can have block detection/
Hope someone has a diagram? or suggestions
Thank you
Tom
--
Tom Grassi
trgrassijr@...