开云体育

just smogged it today again with the weber carb -- rz

Thanks Greg,? i called em.? 12/each and i need 2 so amazon i get 4 of em for less.? done!

Any Toyota dealer - they are about 10 bucks -Greg

Thanks Doug. I will be on the lookout.

i meant the bolts nor the springs . . . this site doesn't seem to allow editing of remarks

yes, i think it would.? I don't need the screws or bolts but need 2 of the plastic gizmos.? Suppose it'll be easier to spend the 20$ than try to find 2 the right size/thread.

This might work: https://www.amazon.com/Screws-Headlight-Plastic-Mighty-X-81131-89103/dp/B0B9WXKKSS [email protected]> wrote:

Hi there,? the plastic gizmo that my top headlight screw goes into broke so i can't keep headlight in proper alignment.? any ideas on how to acquire a replacement?

Throttle position sensor, Idle air control valve, air flowmeter [email protected]> wrote:

A bit of a continuation of some replies on another thread (didn't want to completely high jack it), but here is my question. I have an 87 with a 22RE. I have started to collect a few "hard to find

Yes, but if you have any doubts call customer service. They are very helpful. [email protected]> wrote:

hi doug, which ones did you use?? ?did you use this one?? thanks! PN: 57113 LoadLifter 5000 Air Spring Kit

-- rz? yes it was in sacramento

Rz, was yours smogged in California with that carb? Doug Sent from Yahoo Mail for iPad

Thanks, I was wondering. [email protected]> wrote:

this particular weber-32 36 dgv is arb approved.? mine was smogged with it.? first check with your smog station about legality -- rz

If the vehicle is in a emission testing area installing a Weber would not be a good plan since it would fail inspection, otherwise a Weber will improve power and throttle response. Rebuilt

also, if there was any fuel in it when stored it will have turned to varnish which will need to be removed -- rz

the gaskets and flexible parts shrink over time without fuel exposure.? i would check with napa auto parts for a kit -- rz

Hi there. Thanks for your response. Can you say more about why it will need a kit and where to find one? Thanks! [email protected]> wrote: