开云体育

I just got a quote of $2681.74 to do the 60K-mile valve adjustment and wheel bearing repacks on the toyhouse V6.? Seems kind of excessive... what do you all think?

All things made of rubber eventually deteriorate. The rubber air suspenion bags on ToyHomes have the advantage of NOT being exposed to very high temperatures, heat cycling, or corrosive chemicals.

Vintage Toyota SandTana Motor Home 3999.00 obo if interested please email Nate at diamondheartofdharma@... or call 570 78zero 69five one see below for description. Runs Strong New PA inspection

I had a slow leak on one side and used a spray bottle with soapy water to check over everything. Found a very small bubble leak on a hose connection and tightened it up. Since then they hold air for a

I guess we are all on borrowed time, but the terms of our loans may vary. All joking aside, "I don't know" would be a better answer.? I do know that they are made of good heavy rubber, and the fact

Thanks, Doug.? I have replaced and retightened the valve stem inserts.? I haven't troubleshot it further but it's not critical. My question is more general in nature... do these airbags come with a

It will be either a fitting/connection point as suggest Tika,? or the valve stem.?? Either can be isolated by using something like "Snoop" that is made to find small propane leaks or even plain

Just curious how you're carrying the Champion 2500W generator with the Onan still in place.? Or did you remove the Onan and put the Champion there?

the hose off the top of the spec plac.? remove the hose clamp, the other end where it goes into the air filter housing is the same as a wiring grommet. just wiggle it out -- rz

RZ Where is the crankcase breather? ?And how do I assess a “blockage”? Easily done visually? The 2800 generator with its brand new carburetor and fuel filter ran perfectly for perhaps three

Thanks, Tika and Jim. Tika, yeah, it's mildly annoying but not much, I just top them off every morning when I'm out on the road.? I'm not really concerned about the slow leak, it takes a few days

Tika, if you haven’t already done it, you might check the valve stem on the slow leak side. Jim

Yep. ?How annoying it gets to keep them filled will determine when you decide to replace them. ?But first check to see if it is the lines that are slowly leaking. ?Easier fix.

What is the expected lifetime of the air bags on the rear of our toyhouses? Mine is a 1991 Warrior V6.? I believe the air bags are original, at least they haven't been replaced since we bought it in

Hi-Thanks for the info., if we are still interested we will get in touch with you, it sounds like it can be brought back into shape-

Yes, the resistance between the center wire and the outside should be infinite -- and if it is, then take a bit of aluminum foil and stuff it in at one end of the cable so the inner and outer wires

also while there, check for center conductor to outer braided shield wire.? should be infinite resistance -- rz

No, the access is behind the "wall' inside the cabinet at the end.? However first you need to be sure that the reason you don't have a better signal isn't because the wire from the antenna is

Humbug. Tried the little booster that goes between the tv and cable, and saw no difference in number of channels or picture quality. Guess I'll have to figure out how to wire in one of the old style

A regular bicycle tire pump with a built in pressure gage is always with my tools. About 4 pumps from 20 to 40 psi.?Sent via the Samsung Galaxy S23 5G, an AT&T 5G smartphone