开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育

New FW release: Improved correction curves for ZS406


 

New FW release
Version V1.4193
tinySA Ultra ZS406
?
Changes:
- Improved level correction curves for the ZS406
--
Designer of the tinySA
For more info go to


 

Hi Erik - thanks for all the hard work, much appreciated. Do these new FW upgrades that are specifically identified as being for the new ZSXXX series of analyzers also apply to the original Ultra devices prior to the new series being introduced?
?
Dino


 

开云体育

Erik,
?
How can I determine if my tinySA Ultra is a ZS406?
?
Thanks,
?
Mike N2MS
?
?

On 01/08/2025 2:49 AM EST Erik Kaashoek <erik@...> wrote:
?
?
New FW release
Version V1.4193
tinySA Ultra ZS406
?
Changes:
- Improved level correction curves for the ZS406
--
Designer of the tinySA
For more info go to
_._,_._,_

.


 

It says so on the back beneath the name Zeenko.


 

Also with latest FW?
CONFIG/VERSION
?
--
Designer of the tinySA
For more info go to


 

I have a TinySA that has unknown type number.? I bought it used from eBay and do not know its age.

There is no such number on the label on the backside of my unit.? The only appearance of "ZeenKo" is the very bottom line on the rear label? that reads "Designed by Erik in Netherlands, Made by ZeenKo in China".? Nothing else below it.

Any thoughts?? (I am getting enormously old and I may just not be seeing the type number...)? ;-)

Dan Mail Photo.jpg
Dan Heather N1DH
Middleboro MA


 

If you device has "Ultra" at the front it's a ZS405
If it has "Ultra+" you have either a ZS406 or ZS407 and the label at the back specifies which of the two
--
Designer of the tinySA
For more info go to


 

QSL
?
Thank you Erik! ?Your continued efforts are much appreciated!


 

It shows which version is which in the WiKi.
All you have to do is read it.
?


 

On Wed, Jan 8, 2025 at 06:06 AM, Dino Papas wrote:
Hi Erik - thanks for all the hard work, much appreciated. Do these new FW upgrades that are specifically identified as being for the new ZSXXX series of analyzers also apply to the original Ultra devices prior to the new series being introduced?
Good question...
?
Roger


 

All ultra devices use one common FW?
Inside the FW it is detected which hw is present and the differences are covered by this single sw.
So there is no special zs406 version but a FW release may contain changes relevant to only one hw.
--
Designer of the tinySA
For more info go to


 

Hey Erik! Thanks for all your hard work, it's really appreciated. Just curious, when do you sleep? ?