开云体育

Never one to leave well enough alone when it comes to this stuff I did an upgrade of the TinySA firmware. No matter what version (including building my own from github) I've tried I get errors on the self test #3, 4, 7, and 10.
I've done a clearconfig 1234 and a reset. Calibrating the level also fails. And no, I did not save any earlier configs. Am I missing something or is my unit possibly defective?

Hank W6IR

Did you connect a cable between the Low and High ports?

72

-Jim
NU0C


On Sun, 11 Oct 2020 20:33:17 -0700
"Hank Beisheim via groups.io" <w6ir@...> wrote:

Never one to leave well enough alone when it comes to this stuff I did an upgrade of the TinySA firmware. No matter what version (including building my own from github) I've tried I get errors on the self test #3, 4, 7, and 10.
I've done a clearconfig 1234 and a reset. Calibrating the level also fails. And no, I did not save any earlier configs. Am I missing something or is my unit possibly defective?

Hank W6IR

Failing 3,4,7,and 10 means there is either no cal output signal or a much to strong/weak signal.
Can you start with redoing the powerlevel calibration.
Please post a picture of the screen where the powerlevel calibration states success or failure.
If the powerlevel calibration succeeds,?retry selftest, post a picture of each screen where the test is paused with the failure.

Thanks everyone. Turned out to be a bad cable. Swapped out cables and all is well again.

Hank W6IR

On Mon, Oct 12, 2020 at 07:32 AM, Hank Beisheim wrote:

Turned out to be a bad cable. Swapped out cables and all is well again.

As you are the second person with this problem I added this to the FAQ:?