¿ªÔÆÌåÓý

  1. Tinysa
  2. Topics

Signal level too low or not on frequency

 

after doing the standard calibration I tried to do the calibration above 5.54GHz and this was the response The cable used is the standard one but the response did not change even using high quality cables Has it happened to anyone else? Is there some special procedure?

20240826_221733.jpg

 

have a look to the wiki (TinySA Ultra menu tree):?
  • ?requires an external 5.34GHz signal to remove the harmonic step at 5.34GHz.
?
Toni
 

¿ªÔÆÌåÓý

thank you Toni
I already did this calibration in the past?and all went with no problem
Maybe meanwhile there has been a drift? of some component (?) Anyway?I'll follow the note?at?the link you kindly sent and report back
Adri
?
?
?
?

----- Messaggio originale -----
Da: Toni Ciscar via groups.io <aciscar@...>
Rispondi a: <[email protected]>
Inviato: 27/08/2024 00:53:32
Oggetto: Re: [tinysa] Signal level too low or not on frequency
have a look to the wiki (TinySA Ultra menu tree):?
  • ?requires an external 5.34GHz signal to remove the harmonic step at 5.34GHz.
?
Toni

1 - 3 of 3