开云体育

hello Erik thank you for all the effort you put into the tinySA and the tinySA Ultra. I try, if possible, to reproduce your demos to understand and put into practice. I realize that this time I can't,

Ok, yes, that was too easy to fix. Also no double sided tape on mine either. thank's for help

Hi Dick, I normally just change the span around a signal to get one station expanded on the display. A marker will give that "frequency" and then I can figure out what local FM station is being

Like any spectrum analyzer, you have to use your markers to identify frequency peaks in a given span.? The Ultra has 8 markers you can set versus the 4 for the tinySA. Herb

Got my Ultra yesterday, from R&L Electronics, looks fine and getting used to it. However, I do and will have some questions on its operation. For example, I scan the FM Band and get several signals.

So sad, "out of Stock" -- Walt, WD0GOF, WD0GOF.COM

Barry Brown Mountain Telecom 802-366-3060 barry@...<mailto:barry@...>

You can also see that both DFU devices reported have the same serial number, indicating it comes from the same physical device.

No I did not have any other DFU devices, because if i disconnect the tinySA Ultra it does not see any DFU device when starting the bat file. When the tinySA Ultra is reconnected the bat file again

It seems you had more than on DFU capable device active Make sure the tinySA is the only device connected in DFU mode -- For more info on the tinySA go to https://tinysa.org/wiki/

It looks like I first needed to start the batch file and while it said "Device will detach and attach" switch on the TinaySA Ultra in DFU mode. Then it suddenly upgraded to 512. According 'version

If I execute the bat file DFU_LOAD_BIN.bat as indicated in the wiki, I get the following error:

(From R&L) I was prepared to re-align the lcd, but found mine is perfect so I can get right to the fun!

incorrect version...that one is for the tinySA, not the Ultra

Looks like I used the wrong firmware. It’s working now! Thanks for the guidance. B Sent: Saturday, December 03, 2022 8:10 PM To: [email protected] Subject: Re: [tinysa] Black screen after firmware

The firmware I used is tinySA_v1.3-506-g8291e1e.bin<http://athome.kaashoek.com/tinySA/DFU/tinySA_v1.3-506-g8291e1e.bin>, following the procedure in

Is it possible to just rotate the display in its case?

Did you use the correct file format (bin) and the specific file for the tinySA Ultra (not the tinySA)? Did you follow the steps in Erik's guide?

Just got new Tiny Ultra. Upgraded the firmware per the document using STM32 Cube Programmer. Upgrade went well and Programmer showed that the upload was completed. After turning the unit Off and On,

Hi, Eric, I've also noticed that when I change the brightness of the display, this setting only applies until TinySA is turned off. It would be good if the brightness setting was part of STORE AS