开云体育

Erik, Thank you for putting me out of my misery, over what 'painted' over letters/numbers in black nano you were using while viewing your video related to the PFA demonstration. Geo

Larry Go to the tinySA wiki page on "where to buy" and buy your nanoVNA-H4 from one of these sellers They all sell both tinySA and latest nanoVNA-H4 I have used one of these nanoVNA-H4 for the

I have read the thread: *Where to buy a NanoVNA H4 HW rev 4.3?* These were the last two entries in the tread: Fred, W9KEY 06.10.2022 #29768 ( /g/nanovna-users/message/29768 ) Unsure

Hello, I attached a screen shot of a previous post showing an adapter another person made. Maybe you could make one for your Antenna diameter. Just a thought. Clyde KC7BJE wrote:

Way back in my college days I had a pirate FM radio station (made from a Radio Shack FM transmitter kit) and I didn't know how to build a stereo multiplexer circuit.? But I did know that if I

I believe that there are apps for audio spectrum analysis for the PC (I know that there are some for Android) that would have the resolution required to do what you want.

There are quite a number of audio SAs online as freeware. Pick the one that best suits your needs. The TinySA Ultra specification for minimum RBW is 200 Hz. This should be more than adequate to view

The stereo audio signal modulating the FM carrier consists of the combined channels and a 19 KHz pilot signal used to synchronize the channel switching during separation of the audio into separate

Oh no, I don't like to do a cal each time I switch my NanoVNA on and I always include the cable on the source port into the calibration. So I have not only marked what cable belongs to what VNA, I

Here's a screen shot of the url:

Me too!

Personally I can't tell, mine are mixed and used interchangeably, works for me. Mike C. Sand Mtn GA

RG-316 is a cheap and easy to use cable. Has the same problem, that the shield get broken at the shield-crimp point. But because it is PTFE insulated this can easy resoldered. Have done this on all

What about RG-316 cable? István

Perhaps I'm wrong but, I mount the the antenna on the coax (or longer if needed) Erik provided. ?I've not done it yet but, a wooden support would work as far to holding the antenna. larry

Hi Ed My pleasure Kind regards Kurt Fra: [email protected] <[email protected]> P? vegne af Ed Vignati Sendt: 21. januar 2023 06:40 Til: [email protected] Emne: Re: [tinysa] Release of my article about

Outstanding Kurt, thank you for the hard work and tenacity in writing this manual. Ed kj4fgi

Erik, thank you for the information regarding the default value set. Given the information you and Kurt have provided, I don't need to do a CAL above 5.34GHz for now. Thanks again.

Kurt, thanks for your detailed information. Given what you've said, I'm good with not doing a CAL above 5.34GHz for the time being. Thanks much.

Thanks John. I appreciate the information.