开云体育

Hello, this cables aren't compareable at all. The RG316 is a cable for flexible use. The SS405 is a cable to have a more flexible alternative to the corresponding semirigid cables. The SS405 will

Yes, I would buy for R&L. ?In fact, I just ordered it! Thank you for your reply. larry

What error in the output levels versus frequency did you observe? -- For more info on the tinySA go to https://tinysa.org/wiki/

István, SS405 on

Hello István! Link for You: https://www.koax24.de/produktinfos/koaxialkabel/koaxialkabel-50-ohm/24-32-mm-gr2/ss405.html Datasheet:

I see; even the double shielded RG316 specified only till 3GHz... - this cable almost the same structure and specified till

Hello Erik, A wish for a tinySA3 - will it be possible to separate the correction tables for the reception and generation modes? For example, add a table " *correction low_out* ", and align the

But I work off the Smith Chart. If it doesn't give me a Simth Chart, I'm not interested......???. Not quite true. Your statement is correct. Doing filters. active gain blocks or

Usually the input and output impedance is important for s filter. That can impact the filter performance. ?I am not aware of a way to get that information without the VNS

Sure. But if you have a SA and a TG, You don't need a NanoVna to tune a filter

Erik, Thank you for putting me out of my misery, over what 'painted' over letters/numbers in black nano you were using while viewing your video related to the PFA demonstration. Geo

Larry Go to the tinySA wiki page on "where to buy" and buy your nanoVNA-H4 from one of these sellers They all sell both tinySA and latest nanoVNA-H4 I have used one of these nanoVNA-H4 for the

I have read the thread: *Where to buy a NanoVNA H4 HW rev 4.3?* These were the last two entries in the tread: Fred, W9KEY 06.10.2022 #29768 ( /g/nanovna-users/message/29768

Hello, I attached a screen shot of a previous post showing an adapter another person made. Maybe you could make one for your Antenna diameter. Just a thought. Clyde KC7BJE wrote:

Way back in my college days I had a pirate FM radio station (made from a Radio Shack FM transmitter kit) and I didn't know how to build a stereo multiplexer circuit.? But I did know that if I

I believe that there are apps for audio spectrum analysis for the PC (I know that there are some for Android) that would have the resolution required to do what you want.

There are quite a number of audio SAs online as freeware. Pick the one that best suits your needs. The TinySA Ultra specification for minimum RBW is 200 Hz. This should be more than adequate to

The stereo audio signal modulating the FM carrier consists of the combined channels and a 19 KHz pilot signal used to synchronize the channel switching during separation of the audio into separate

Oh no, I don't like to do a cal each time I switch my NanoVNA on and I always include the cable on the source port into the calibration. So I have not only marked what cable belongs to what VNA, I

Here's a screen shot of the url: