开云体育

Test 7 below also, I updated the firmware to the most current version in an attempt to correct the calibration issue. Got the same results as before. -- Scott Nolde

Steven, Thanks from me as well. I always thought (wrongly) that the NanoVNA-H4 was sub to the VNA-F. I guess I liked the larger screen and updated 5000mA battery install options by the sellers. I was

Hi Ed the SW gor the TinySA works only with the NanoVNA-H4 the SAA-2N or NanoVNA-F are different in the hardware, it would not be possible to use this devices. Erik has a forum on the website he

I AGREE........on the thought. Anything that can help us all out here, when it come to full utilization of the TinySA, is not 'OFF Topic'................

Printed with PLA. I haven't tried PETG yet. And yes, "Supports Everywhere". The hinge supports actually remained on the print bed when I removed the print. The attenuator support easily and cleanly

Hell, back in my day LPUO meant to not pick up any foreign women going out on a date.

Hi Scott Eric need always selftest no 7 ;) This can be created using a serial over USB command selftest 0 7 with this test he knows clone or not a clone, if it is a clone (normally the original

LPUO = Local Pick Up Only :)

Just as long as 'LPUO' isn't Russia, Ukraine, China or Washington D.C. (FBI) field office, $30 is still a good price. Will you be accepting PayPal or 'Food Stamps'?

You and me both..I should have known that one.

Wow, did I miss the obvious. I'm throwing away my code book and taking up dancing.

"LPUO"-----------Even thought I was a 'Code Cracker' during WWI (many moons ago) I can not for the life of me figure this one out. Can someone help? L.P.U.O. must be an acronym to something that I am

Hello Everyone new to the group and need some assistance. Just received my TinySA and it will not pass calibration without critical warnings. How do I repair it? Here are some pictures of the new

LPUO: ?Local Pick Up Only Sent from Yahoo Mail for iPad

Looks good. I printed two of them originally, one for my original TonySA, one for my nanoVNA. And once the Ultra arrived, I couldn't let it go without a case, and I can't say thank you enough to Jeff

Yes! ? ? ? ? ? larry

Thanks very much for this method Peer, immediately brought back memories from my first job, we used to have two " wobbulators " to align central antenna amplifiers and umsetzer's ( frequency

Looks good!? Did you print that with no supports?? And is it PLA or PETG?? I personally print almost exclusively with PETG, and the only downside is that it doesn't bridge well, so if I print

You?re welcome…it is important to set the sweep points to 145 when you use 50 msec as the TinySA can?t achieve 50msec with more sweep points. Furthermore this only works with the TinySA and NOT

I was unaware of the cases on Thingiverse. Started printing my cases last night, lower half of tinySA case came out perfect! My offer to trade a 3d printer for an Ultra still stands, LPUO!! Mitch