开云体育

As I possess two (new) TinyAS Ultra modules I tried to enable the external modulation option however it seems this function is not available in the ultra. How can I proceed, is this solved differently

Hi Peer, Thank you. It was very helpful for me. JR1KDA / Sho

It's now solved trying a different USB port in the computer. Thank you, Antoine

Hi Martin, Trying a different USB port in my computer solved the problem, My tinySA is now upgraded with the latest FW, thank you for your very effective tip. Also I'm going to make the HW

Hi Larry , please check-out https://github.com/ryanvolz/radioconda. i installed pyserial using Conda. Kind Regards Patrick

Thanks Erik for your quick response. Regards, Toni

With newer FW the calibration flag is only set after doing an actual calibration. -- For more info on the tinySA go to https://tinysa.org/wiki/

The clear config code is 1234 -- For more info on the tinySA go to https://tinysa.org/wiki/

After a FW update: Up to FW version tinySA_v1.3-429-gc224fa9 2022-07-05, after entering the leveloffset values by console, the upper and lower display scale level indicators and the LOW mode

Hello Sarayut Hatsanai! Why 4321? Via console of tinySA APP "clearconfig 1234" or does tinySA4 Ultra work differently? Vladimir, dl7pga

if you don?t have a demod probe the oscilloscope will look like this Von: [email protected] <[email protected]> Im Auftrag von Peer Gesendet: Sonntag, 8. Januar 2023 11:29 An: [email protected] Cc:

I assume you did check the coax cable. If all else fail contact your supplier -- For more info on the tinySA go to https://tinysa.org/wiki/

I Cleared config but still have same problem

Hopefully the file is not too big.. Von: [email protected] <[email protected]> Im Auftrag von JR1KDA Gesendet: Sonntag, 8. Januar 2023 04:06 An: [email protected] Cc: ktm@... Betreff: Re:

Sorry, it's an ultra. I was confused. Can you do a CONFIG/CLEAR CONFIG -- For more info on the tinySA go to https://tinysa.org/wiki/

One remark to all FW hackers, If you want to avoid repeatedly opening the case to restore after a failed FW update, you can make a small HW modification: Solder a wire from BOOT0 to the middle pin of

Hi Antoine, Did you try with a different USB cable or with a different USB port of your computer? Martin

Please post photo of back cover of tinySA -- For more info on the tinySA go to https://tinysa.org/wiki/

I try re calibration but still have a problem, I generate from know signal and correct it work fine only low frequency but at high frequency above 100Mhz level not correct.