开云体育

Fine to use harmonics, but how do you know your level at the harmonic frequency is correct unless you either have a second spectrum analyzer, or your setup includes a selective form of power

My Ultra arrived yesterday from R&L.? The screen is crooked but firmly attached.? Any suggestions on how to release the tape and re-apply? Thanks Rich

I did try to use harmonics of the tinySA 9x 593 MHz and 12x 445 MHz

Some devices seem to have trouble with the tip shape, however! A simple cure is to obtain the kind of inexpensive headset splitter cable with 3.5mm stereo output plugs for the headphone and

Yes, see wiki where to buy -- For more info on the tinySA go to https://tinysa.org/wiki/

For calibration above 5.34GHz you need to provide a 5.34GHz input signal into the RF input. -- For more info on the tinySA go to https://tinysa.org/wiki/

I'm seeing- "Signal level too low Touch screen to continue" When I try to do "CALIBRATE above 5.34GHz" The Wiki doesn't seen to actually cover initial setup of the ULTRA yet.

I've just got one from Mirfield Electronics, are the a valid seller?

I was under the impression that I had ordered the Ultra through Zeenko, but when I received the order it said it was through the Geek seller which is why I questioned it. I am in the process of

Thank you. This is what I was looking for. I am not too concerned about updating - DFU mode. Just being able to capture screen on the PC. Dave - W?LEV [email protected]> wrote:

You have to be very careful when you use a wideband noise generator as a substitute for a tracking generator.? The reason is that the tinySA and tinySA Ultra? have maximum input power limits of +10

Check this https://tinysa.org/wiki/pmwiki.php?n=Main.PCSW [email protected]> wrote:

check this [email protected]> wrote:

If you mean the firmware update procedure the answer is Yes. Same drivers as NanoVNA for serial port data exchange and DFU firmware update. There is only one app and it is called tinySA app and it

Yes Clyde KC7BJE

I received the email yesterday stating my TinySA Ultra shipped. UPS delivered it today.? The display a little loose on the top. Gentle pressure on the edge of the display solved the problem.? Time

Is the TinySA Ultra with the 4" screen supported with SW/FW over USB much line the NANOVNAs? -- *Dave - W?LEV*

Zeenko is the valid store in Aliexpress: https://es.aliexpress.com/item/1005004934403303.html?gatewayAdapt=glo2esp

You guys got me thinking (understand I'm very new to spectrum analyzers).? Comments were made about tracking generators, noise and other types of wave sweeps.? So I found on my Feeltech FY6600 a

Thanks Erik, that is what made me query it.