开云体育

Thank You

-- For more info on the tinySA go to https://tinysa.org/wiki/

I'm new to the tiny SA, received one for Christmas. Can you point me to the manual ? Thanks, John Myers II

Hi No artifacts!! Thanks??? Joe.

I updated with the lates, and no problem here. Kind Regards, Dave Dave Reiser

Joe, I've updated the release. Can you check if the artifacts are gone? -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi Erik. The 'level meter' check mark stays stuck if I turn off and then on the TinySA (so have to uncheck and check again to get the 'level' display. The 'level display' is not 'sticky' on saving a

Thank you Patrice,? yes, reading the manual is a good thing!

The code is in the manual see "Clear config " on https://www.tinysa.org/wiki here https://tinysa.org/wiki/pmwiki.php?n=Main.SETTINGS3 All is described see the manual.... [email protected]> a

Hi Can not get it to display properly... After FW loading, no trace display. After enabling the trace it does not 'stick' (have to enable trace every recall of presets,every start) ( 'clear config'

Here with me it was necessary to do a clear Config to have the spectrum display again.

Thank you! All is good Rich

Trace must be enabled...

It also appears that it will not pass the self test #10 Stopband Critical I reloaded the FW and the same behavior continues

I just updated to 1.3331 and now I have no spectrum display at all.?? The labels on the left and right are there but no waterfall or analog graph ?? Does something need reset? Thanks Rich

New FW released Version 1.3331 Changes: - DISPLAY/LEVEL METER option added to show BIG letter marker info This new feature will, when enabled, display the value of the first active marker at the

Someone it asked us to share Self-Test results ... here's mine ...

Hi Erik. Thank you for the quick response,? the tinySA gets? better and better! Joe.

Good catch, forgot to update the wiki with the updated correction command. You have to specify which correction table to use as there is now also a correction table for the high input ch>

Hi all, think I'm making a rookie error but can't see it so could do with a pointer. ?I've just updated my unit to 1.3-330. ?This is my first time updating the firmware. ?I saved the leveloffset