开云体育

Confirmed.? Can use manul attenuation to avoid the bad combinations.? I found the attenuator ICs on ebay so plan to attempt repair. Also ordered 2nd tinySA.? Useful to have one as sig-gen while

The level calibration fails when the attenuator is blown. You can perform a manual level calibration that avoids the negative impact of the broken attenuator Connect two SMA Enable CAL output at

wrpowell2002,? I have the very similar (surprisingly similar) attenuator results. *Did you have the to ports connected to each other during the firmware update?* I'm thinking possibly the transceiver

Sorry, but this only works on a local server running M$ Exchange :-) -- Dave

Dave Reiser would like to recall the message, "Re: Re: [tinysa] Stopband Critical and Attenuator Fail Notifications".

Kind Regards, Dave Dave Reiser Phone: 301-216-5394 Mobile: 301-802-1929 Email: davereiser@...<mailto:davereiser@...> 520 Russell Avenue, Gaithersburg, MD 20877

Yes, I did more than once. Tests still fail. Based on what I have seen while researching, I think I have somehow damaged at least part of the attenuator circuit. Don't know how, but if it is that

Did you run the levelcalibration ? Jos Op 21-12-2021 om 17:29 schreef wrpowell2002 via groups.io: -- Dit e-mailbericht is gecontroleerd op virussen met Avast

Indeed, the attenuator is blown up. -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Sorry, I thought I posted that as a reply to the original post. Here it is. Thank you for such a fast response.

Can you do the test as described here: https://tinysa.org/wiki/pmwiki.php?n=Main.CheckTheAttenuator and post a picture of the final screen showing the green

Something I just tried changed the results. I did a factory reset and then set the frequency range to 100 - 150 MHz and reran the test. Only Test 12 Attenuator failed.

Today I was going through some of the documentation with my TinySA to learn more about it. Running a self test errors starting showing up and I would like to know if I am the cause of the problem or

Thank you all in the end I ordered one based on the hmc213 to see how it goes. A greeting.

Indeed, you only need to update tinySA-App.exe and you can keep the current tinySA-App.ini No other files are needed. -- ------------------------------------------ For more info on the tinySA go to

Ok, I already installed the tinySA-App a few months ago. At that time I did it the way you mentioned, with the normal right-click and "Save As...", but I downloaded all the files, also with subfolder

Yes -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Did you mean "IAM 81008"?? Mike C.

Old FW's (before say this summer) will go to +16dBm. Later Fw's only to +9dBm The old high output level was too destructive to I reduced the maximum. -- ------------------------------------------ For

yes, it's working .