开云体育

Great video! I also got 2 more tinySAs from R&L today :-) Now I have to make a bunch of output filters. Have Fun! Reg

Erik, Your latest video on the comparison of a Siglent and Tiny SA is most interesting and informative. It is truly amazing that such a low cost instrument can perform as well, or exceed the

Isn't 3-D printing plastic? 73, Bill KU8H bark less - wag more

Lettering looks real sharp, but sounds like a slippery slope. And without it the same case would be appropriate for the smaller 2.8" NanoVNA(s), including clones. I'd rather print my own generic

I am assembling a portable RF bench setup with a nanaoVNA and 3 tinySAs among other things. I would very much like to be able to use a GPSDO (e.g. RFzero) to synchronize all of them. With

I have made my adjustments and finished printing the lower half overnight.? Once the upper half is complete I will update with some new images and thoughts/conclusions.? If I am happy with this one,

A direct comparison of a tinySA and a Siglent SSA3021X+ while measuring signal levels and harmonics. Various aspects of level measurements are explained and

Very nice! If you were to sell one of these, I’d buy one. Thanks for sharing.

Hello spiff72, That looks very good. Your additional tweaks make much sense. I would like to print it :-) 73, Rudi DL5DA

Excelente Sent from Android device

Hey all, Just wanted to share a 3D printed case I designed around the tinySA.? It is still a work in progress, but I am attaching a few photos of the first print trial, as well as some screen grabs

Reg, -30dBc was the minimum specification for a lot of the commercial testing that I performed, so -55dBc sounds outstanding to me. Herb

Herb, This is not for creating a tracking generator for the tinySA. It's for evaluating mixer performance as a function of drive levels, Vcc, etc. Just being able to synchronize a pair of tinySAs

Gyula, Nice project and definitely shows

Herb, As far as I know, Glenn did not continue, he stayed with the two RF panel versions. Last July, I started building to replicate the situation at the time. When TinySA was released, it was

Reg, When using two tinySA's with an external mixer to create a tracking generator setup, ensure you pay attention to Erik's note about using a preamp and attenuator to increase isolation.? Without

Well, Herb, funny you should mention this. *My* tinySA will have TWO tracking generators ;-) I ordered 2 more from R&L. All that's lacking is software to synchronize 3 tinySAs and a GPSDO

Just a FW update -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Great - thanks! Is the white versus yellow text for the top of the screen meaningful, or was that just a firmware update change?

Ok. Got it. That's what I was suspecting. Thanks for confirming. Nagi